Manuals / Brands / Computer Equipment / Network Card / Freescale Semiconductor / Computer Equipment / Network Card

Freescale Semiconductor i.MX27 PDK 1.0 Connect Development Platform to PC; Run Preloaded Image

1 46

Download 46 pages, 912.28 Kb

Build the Platform

Build a Development Platform: Assemble Three Boards

20

i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0

Connect Development Platform to PC; Run Preloaded Image

Figure 3.4 Connecting the Platform to your PC

To connect the 3-Stack platform to your host PC:

1. Connect one end of an RS-232 serial cable (include d in the kit) to a serial port

connector (CON4) on the Debug board and co nne ct the ot her end t o a COM port on t he

host PC.

• Configure SW4-1 to ON.

• Make sure that SW4-8 is ON, to supply power to all three boards.

• Configure SW4-2 to OFF.

2. Confirm that the Bootstrap switches (SW5–SW10) are set for NAND boot. See Table

3.1.

Table 3.1 Boot Mode Setting (SW5–SW10)

Boot Mode

Device

SW5 SW6

(Boot4)

SW7

(Boot3)

SW8 SW9 SW10

UART/USB

bootloader

X0 0 00 0

8-bit NAND Flash

(2KB page) Ext

X0 0 01 0

RS-232

cable

COM port

Female

1

3

4

5

6

DC

power

Regulated +5V

DC Supply

J2

S4 Configure serial

console application.

Set Bootstrap switches

(SW5–SW10) to NAND boot

2

Set SW4

3StackQS_WinCE.book Page 20 Fri day, November 21, 2008 11:46 AM

Contents

Main Page 1 About the Boards 3 2 Getting Started 13 3 Build the Platfor m 17 4 Using the Demo Image 25 Page About the Boards About the 3-Stack Platform System Page About the 3-Stack Platform System 5 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Table 1.1 3-Stack Platform Features Details Page CPU Board CPU Board Debug Board 8i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Debug Board Figure 1.2 Debug Board Debug Board TOP Bottom Page Page Personality Board 11 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Personality Board TOP Bottom Figure 1.3 Personality Board Personality Board Personality Board 12 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Table 1.5 Personality Board Physical Features Type Physical Feature Getting Started Unpack the Kit Page CD-ROM Contents 15 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 CD-ROM Contents Table 2.2.identifies the items on t he CD-ROM set. Table 2.2 Development PC Requirements Type Requirement Provide a Development PC Build the Platform Build a Development Platform: Assemble Three Boards Connect Personality Board to Debug Board Connect CPU Board to Debug Board Connect Development Platform to PC; Run Preloaded Image Build a Demo Platform: Assemble Two Boards Connect CPU Board to Personality Board Page Connect Power Supply; Run Preloaded Demo Page Using the Demo Image Touch Pad Calibration Tool Page Downloading Multimedia to the 3-Stack Board Using Active Sync Page Page Page Page Using an SD Card Using a USB Memory Stick Running the Demo Applications Running the TV-Out Application Page Page Page Page Page Page Page Page Ready to Begin Your Development?