Friedrich A-SERIES manual Table of Contents

920-075-08

		Table of Contents
I.	General Specifications
	Installation Recommendations	3
	Model Number Identification Guide	4
	VERT-I-PAK Chassis Specifications	4

II.Installation

1.	Utility Closet Dimensions	5
2.	Wall Plenum & Architectural Louver Installation	6
3.	Electrical Information	7-9
4.	Indoor Return Air Grille Installation	10
5.	Ductwork Preparation and CFM	11
6.	Chassis Installation	11
7. Chassis Final Connections (Electrical, Duct, Drain & Wall Thermostat)		12
8.	Final Installation Checklist	12

III.Chassis Operation

9.	Thermostat Control	13
10.	Low Ambient Protection for Compressor & Fan	13
11.	Heating Defrost (Heat Pump Models only)	13
12.	Fresh Air Door	13
13.	Condensate Disposal System	13
IV.	Service & Warranty
14.	Servicing / Chassis Quick Changeouts	13
15.	Warranty	14
V.	Vert-I-Pak Accessories	15

Please read this manual thoroughly prior to equipment installation or operation. It is the installer’s responsibility to properly apply and install the equipment. Installation must be in conformance with the NFPA 70-2002 National Electric Code or current edition and Universal Mechanical Code current edition and applicable local or national codes.

Proper installation is not difficult but it is essential.

2