Installation Instructions
Install the Air Conditioner in the Case
Step 1. Slide the air conditioner into the case. Reinstall the 2 screws removed earlier on each side of the case.
Step 3. Attach the front grille to the case by inserting the tabs on the grille into the slots on the front of the case. Push the grille in until it snaps into place.
Power Cord
Screw
Screw
Step 2. Before installing the front grille, pull out the vent control lever located above the unit control knobs, as shown.
When you detach the front grille from the case, push the grille to your right side and pull it toward you.
Step 4. Lift the inlet grille and secure the front grille with a Type A screw. Lower the inlet grille into place.
To Reverse the Grille Opening
The Friedrich KQ08E10 has a reversible grille. The grille is designed to |
| |
open from both the top and the bottom. |
| |
To reverse the grille opening, you must follow the following steps; |
| |
Step 1. Pull the entire grille of the front of the unit and locate the hinges |
| |
| that hold the grille in place on the inside of the grille. |
|
Step 2. | Insert the tip of a flat screwdriver in between one of the Hinges and | Inlet Grille |
| the ball shaped bearing of the grille. |
|
Step 3. | Very carefully pull the bearing out of the socket of the Hinge and |
|
| repeat steps |
|
Step 4. | Locate the top hinges on the grille. |
|
Step 5. | Turn the grille upside down. Using flat screwdriver, create an |
|
| opening on the top hinge and insert the ball shaped bearing to |
|
| snap the grille in place. Repeat the same steps on the remaining |
|
| hinge. |
|
14
