NAME OF PARTS
Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
●When kept on pressing the MANUAL AUTO button for more than 10 seconds, the forced cooling operation will start.
●The forced cooling operation is used at the time of installation.
Only for authorized service personnel's use.
●When the forced cooling operation starts by any chance, press the START/STOP but- ton to stop the operation.
3Indicator (Fig. 3)
4Remote Control Signal Receiver
5 OPERATION Indicator Lamp (red)
6 TIMER Indicator Lamp (green)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See Page 15 Auto Restart).
7SUPER QUIET Indicator Lamp (green)
8 COIL DRY Indicator Lamp (orange)
9Intake Grille (Fig. 4)
0 Front Panel A Air Filter
B Air Flow Direction Louver C
(behind Air Flow Direction Louver) D Drain Hose
E Air Cleaning Filter
●Refer to the folded out page on the cover.
Fig. 5 Remote Control Unit
FSLEEP button
GMASTER CONTROL button H SET TEMP. button ( / ) I COIL DRY button
J Signal Transmitter K TIMER MODE button
L TIMER SET ( / ) button M FAN CONTROL button
N START/STOP button O SET button
P SWING button Q RESET button
R TEST RUN button
●This button is used when installing the conditioner, and should not be used un- der normal conditions, as it will cause the air conditioner’s thermostat function to op- erate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the Indoor Unit’s OPERA- TION Indicator Lamp and TIMER Indicator Lamp will begin to flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
SCLOCK ADJUST button
TRemote Control Unit Display (Fig. 6) U Transmit Indicator
V Clock Display
W Operating Mode Display X Timer Mode Display
Y Fan Speed Display
Z Temperature SET Display [ COIL DRY Display
\ SLEEP Display ] SWING Display