How to operate your Friedrich room air conditioner
| Off |
|
Fan |
| Low |
Only |
| Cool |
|
| Mode |
High |
| Med |
Cool |
| Cool |
Yes | No | Money Saver |
Temperature
Warmer Cooler
Wait three minutes before restarting
To start unit
If your air conditioner is installed and plugged into a properly grounded receptacle, it is ready to operate.
Mode control
This dial allows you to select cooling at three different speeds, as well as Fan Only.
Off- turns the unit off.
Hi Cool- for quick cooling.
Med Cool- to maintain a desired temperature.
Lo Cool- for night time use, or when demand is low.
Fan Only- will circulate air in the room without the compressor coming on.
This setting can also be used with the EXHAUST air setting to remove stale air or smoke from the room; or it can be used with the FRESH AIR setting to bring outside air into the room. This is especially useful in the spring and fall when cooling may not be necessary. The FRESH AIR and EXHAUST controls are in the upper air discharge area. The center position of this control is the normal, or closed position, which recirculates air for maximum performance in the cooling mode.
Temperature control
This dial is the thermostat. Turn it clockwise for cooler temperature and counterclockwise for warmer.
Figure 3
MoneySaver® switch
This rocker switch can be depressed to either Yes or No. The Yes position provide the most economical operation. Both the fan and compressor will cycle on and off together, maintaining the selected temperature at a more constant level and reducing the humidity more efficiently. This control will only operate when the unit is in a Cool mode. In the No position, the fan will run constantly as long as the unit is in the cooling mode.
4
