Manuals / Friedrich / Household Appliance / Air Conditioner

Friedrich SQ06, SQ10, SQ05, SQ08 operation manual Solid Masonry Construction

Models: SQ08 SQ05 SQ06 SQ10

1 36

Download 36 pages 27.03 Kb

Page 29

SOLID MASONRY CONSTRUCTION

Figure 24

FRONT EDGE OF LOUVERS
MUST ALWAYS BE OUTSIDE OF
EXTERIOR WALL SURFACE.		3/4” MINIMUM FRONT
		3/4” MINIMUM FRONT
		EDGE OF CABINET TO
		INSIDE WALL SURFACE.
3/4” MINIMUM		TRIM AROUND THE
		TRIM AROUND THE
		CABINET WITH A
CABINET FRONT		SUITABLE WOOD
CABINET FRONT		MOULDING AND
		MOULDING AND
		FINISH TO SUIT.
1” THICK LUMBER		CAULK ALL AROUND
1” THICK LUMBER		CABINET ON OUTSIDE
		CABINET ON OUTSIDE
		TO INSURE A WEATHER
		TIGHT SEAL.
1” MINIMUM	1/4” SLOPE DOWN.
	1/4” SLOPE DOWN.
INSIDE WALL	POSITION AND SECURE
	CABINET DOWNWARD.
EXTERIOR WALL	SLOPE OUTSIDE FOR
EXTERIOR WALL	DRAINAGE.
	DRAINAGE.
MAX. WALL		7/8” SLOTTED HEAD SCREWS (3 EA. SIDE)
THICKNESS		NAILS MAY BE USED IF DESIRED.
ALLOWED 8-1/2”		FRR092
		FRR092

STEP 7. &XWWZRSLHFHVRIVWDQGDUGOXPEHUVXSSOLHGE\LQVWDOOHU to the length and width required. Place in front and back of bottom sill channel as shown in Figure 24. Secure with nails (supplied by installer).

STEP 8. Seal all holes in the cabinet with caulking compound (supplied by installer).

STEP 9. &RPSOHWHWKHLQVWDOODWLRQE\IROORZLQJ67(36WKURXJKRI 6WDQGDUG:LQGRZ,QVWDOODWLRQ3DJH:LQGRZ6HDO*DVNHW mentioned in STEP 9 will not be required.

IMPORTANT: %HIRUH RSHUDWLQJ \RXU XQLW UHDG 67(3 RI 6WDQGDUG Window Instructions.

Figure 25

SOLID MASONRY CONSTRUCTION

CABINET

MORTAR

NOTE: ELECTRICAL RECEPTACLE LOCATION

FROM POINT “X” MUST BE WITHIN A MAXIMUM

RADIUS OF 69” FOR 115V UNITS.

CAULK ALL SIDES

ELECTRICAL

RECEPTACLE

POINT “X”	FRR093

29

Image 29

Friedrich SQ06, SQ10, SQ05, SQ08 operation manual Solid Masonry Construction

Contents

Q Chassis Models RoomAirConditionersSYSTEM FAN MODERegister your air conditioner THANK YOU, on behalf of our entire companyfor making such a wise purchase Table of Contents Refrigeration system under high pressure Safety PrecautionsSTEP Unpacking InstructionsSTEP STEPElectrical Shock Hazard WARNING Before Operating Your UnitDo not use the LCDI device as an ON/OFF switch STEP Premium Carbon Filter Installation InstructionsSTEP STEPControl Panel Operation Wireless Programming and Control Kühl Control OptionsPre-ProgrammedScheduling Options Customizable Programming OptionsAUTO Control Panel Operation InstructionsCOOL MODE HEAT MODEOTHER FUNCTIONS 11AMTIMER SCHEDULE - The DIM Function ºF - ºC SelectLock Control Panel AlertsADVANCED FUNCTIONS Timer/Schedule SelectExternal Control Status Timer Stop Time 21ONModify the TIMER Function Timer Start Time Schedule ON Scenarios Timer - Scheduler Control BlockThe display shows a normal system Timer ON ScenariosScheduler OFF Scenarios The display shows the unit in Schedule modestate Timer OFF ScenariosThe display shows a normal system The display shows a normal systemRemote Effectiveness Remote Control OperationTOP VIEW SIDE VIEWAUTO FAN AUTO FAN MODE CONTINUOUSElectrical Shock Hazard Installation Instructions$LUÁRZ6HOHFWLRQDQG$GMXVWPHQW DESCRIPTION ITEM NOITEM NO DESCRIPTIONFalling Object Hazard Standard Window InstallationSTEP STEPElectrical Shock Hazard SECTION A-AExcessive Weight Hazard Unplug unit Cord Routing ChangeElectrical Shock Hazard Figure 18BFACTORY SETTING WITH LEFT-SIDE CONCRETE BLOCK CONSTRUCTION Thru-the-wallInstallationFalling Object Hazard FRAME CONSTRUCTIONSOLID MASONRY CONSTRUCTION This is a warm weather appliance Final Inspection & Start-upChecklistCondensation is normal FrostingAvailable Accessories Routine MaintenanceService and Assistance 203/$,17 Troubleshooting Tips$86 62/87,21203/$,17 The outside temperature is below$86 62/87,21Residene AddendumCommercial Schedule PeriodSECOND THROUGH FIFTH YEAR ROOM AIR CONDITIONERS LIMITED WARRANTYFIRST YEAR 93001001