How to use the remote control*
Figure 5 |
|
|
|
|
6 | TEMPERATURE |
| 5 | |
|
|
| ||
Cooler | Warmer | 1 | ||
2 | POWER |
| 7 | |
Cool |
|
| ||
|
|
|
| |
3 |
|
|
| 4 |
Fan |
| Fan | Money |
|
Only | Speed | Saver® | 10 | |
9 | TIMER OPERATION |
| ||
On/Off | Start | Stop | Set Hr. |
|
11 |
|
|
| 8 |
To start unit
1POWER - Press the POWER button once. The unit will automatically turn on in the mode and fan speed it was last left on.
To set mode of operation
2COOL - Press the COOL button to automatically switch the operating mode to COOL.
3FAN ONLY - Press the FAN ONLY button if you want to run the fan only. You may want to use this feature in conjunction with the FRESH AIR/ EXHAUST if you want to bring outside air into the room, or exhaust stale air. (The FRESH AIR / EXHAUST feature is located on the front of the air conditioner near the top. See page 7, Figure 8.)
4MoneySaver® - Press the MoneySaver® button to activate the MoneySaver® feature. MoneySaver® is the feature that cycles the fan with the compressor so that the fan does not run all the time.
To adjust temperature
5WARMER - Press the TEMP 
button to raise the temperature setting.
6COOLER - Press the TEMP 
button to lower the temperature setting.
To adjust fan speed
7FAN SPEED - Press the FAN SPEED button to see the current setting. Press again to change the fan speed. F1 is the lowest setting (SLEEP SETTING), F2 is low speed (LOW), F3 is medium (MED), and F4 is high (HIGH).
To set the hour clock
8SET HOUR CLOCK - Press SET HOUR once to see the current clock setting. Continue pressing the button until you arrive at the current time. MAKE SURE YOU SET THE A.M. AND P.M. PROPERLY. (NOTE: MINUTES ARE NOT SHOWN ON THE DISPLAY.) A light will appear in the upper left corner of the display when the hour is P.M.
To set the timer
NOTE: Set the hour clock before attempting to set timer functions. You can set the timer ON/OFF a minimum of one hour apart, and a maximum of 23 hours apart.
9TIMER START - Press START to view the current start time for cooling. Continue pressing the START button until you arrive at the start time you desire. The start time for cooling will then be set.
10TIMER STOP - Press the STOP button. Continue pressing the STOP button until you arrive at the stop time you desire. The stop time for cooling will then be set.
11TIMER ON/OFF - Press the ON/OFF button once to activate (light on) or deactivate (light off) the timer. Once the START and STOP times have been selected, they will remain in memory, and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the HOUR CLOCK must be reset or the TIMER ON/OFF functions will not work.
*A Friedrich RC1 wireless remote control can be used to operate all QuietMaster® Electronic models.
6
