Friedrich SS09 manual To adjust fan speed, To activate smart fan, To deactivate smart fan

920-090-05 (10-04)

How to operate your Friedrich room air conditioner

To adjust temperature [60°F (16°C) to 90°F (32°C)]

6COOLER - Touch COOLER to see setting, touch again to change.

7WARMER - Touch WARMER to see setting, touch again to change.

8Touch °F/°C to show desired temperature in Fahrenheit or Celsius.

To adjust fan speed

9Touch SPEED 1-4 to see current setting. Touch again to change speed. F1 is the lowest setting (SLEEP SETTING), F2 is low speed (LOW), F3 is medium speed (MED), F4 is high speed (HIGH).

To activate smart fan

10Touch SMART FAN (light on). Smart Fan will adjust the fan speed automatically to maintain the desired comfort level. For example, if the outside doors in your home are open for an extended period of time, or more people enter a room, Smart Fan may adjust to a higher fan speed to compensate for the increased heat load. This keeps you from having to adjust the fan speed on your own. Smart Fan cannot be activated in the FAN ONLY mode.

To deactivate smart fan

11 Touch SPEED 1-4, and select your desired fan speed.

To set hour clock

12Press SET HOUR CLOCK once to see the current clock setting. Continue pressing the button until the hour closest to the actual time appears in the display. MAKE SURE YOU SET A.M. AND P.M. PROPERLY. A light will appear in the upper left corner of the display when the hour is p.m.

Minutes will NOT show on display.

To set the timer

NOTE: SET HOUR CLOCK before attempting to set timer functions.

You can set the A/C START and A/C STOP timer a minimum of one hour apart and a maximum of twenty- three hours apart.

13TIMER STOP - Press the A/C STOP button and hold until the hour you want the unit to shut off appears in the display (A.M. or P.M.). The stop time for cooling will then be set.

Figure 4

PM

72	Set Hour	Check
	Clock	Filter

Press to reset

On/Off

Cool Money Fan

Saver Only

Cooler Warmer 0F/0C

Speed Smart

1-4 Fan

A/C	A/C	Timer
Stop	Start	On/Off

14START TIME - Press A/C START to view the current start time for cooling. Continue pressing until the hour you want the unit to start appears in the display (A.M. or P.M.). The start time for cooling will then be set.

15Press the TIMER ON/ OFF button once to activate (light on) the timer function. Touch TIMER ON / OFF again (light off) to cancel the timer function if you so desire. Once the on and off times have been selected, they will remain in memory, and cycle daily until changed.

NOTE: If unit is unplugged or power is interrupted, the SET HOUR CLOCK button must be reset or the TIMER ON/OFF functions will not work.

Automatic component protection

Your unit is equipped with Automatic Component Protection.

To protect the compressor of the unit, there is a three minute time delay if you turn the unit off or if power is interrupted. The fan will not be affected.

Also, if you switch from COOL mode to FAN ONLY, and switch back to COOL mode, there is a three minute delay before the compressor comes back on.

5