Operating Instructions
Controls
FAN SPEED
Every time you push this button,it advances the setting as follows:{High[F2]
Low[F1]}
High[F2]
TIMER
You will usually use
REMOTE CONTROL SIGNAL
RECEIVER
TEMPERATURE SETTING
Use this button to automatically control the temperature of the room
The tmeperature can be set within a range of
。 。 。
60 F to 86 F by increments of 1 F.
The setting appears in the display.
POWER
To turn the air conditioner ON,push this button. To turn the air conditioner OFF,push the button again.
This button takes priority over any other button.
If unit is running,use Timer to set number of hours until
For your sleeping comfort，once Timer is set，the Temperature
。
setting will raise 2 F after 30 min，and once again after another 30 min.
Push Timer button to advance setting from 1Hour→ 2Hour →...
→12Hours maximum.
START TIME
If unit is off,use Timer to set number of hours before nuit starts.
Push Timer button to advance setting from 1Hour→ 2Hour →...
→12Hours maximum.
MODE
Push this button to shift mode of operation from COOL → MONEY SAVER→ FAN ONLY→HEAT
COOL:
Fan runs continually for normal cooling operation.
MONEY SAVER:
The fan stops when the compressor stops cooling.Approximately every 3 minutes the fan will turn on and the nuit will
check the room air temperature to determine if cooling is needed.
FAN ONLY:
HEAT:
Fan runs continually for normal heating operation.
AUTO RESTART
When power is restored after an electrical power failure,the unit will begin to run at its last setting.
