Friedrich UE10C33, UE12C33, UE08C13 Refrigerating Cycle, Condenser, Evaporator, Capillary Tube

Disassembly Instructions

RefrigeratingCycle

CAUTION

Discharge the refrigerant system using FreonTM Recovery System.

If there is no valve to attach the recovery system, install one (such as a WATCO A-1) before vent- ing the FreonTM. Leave the valve in place after servicing the system.

12. CONDENSER
1.	Remove the cabinet. (Refer to section 2)
2.	Remove the brace and the shroud cover.
	(Refer to section 4)
3.	Remove the 5 screws which fasten the condenser.
4.	After discharging the refrigerant completely,
	unbraze the interconnecting tube at the condenser	FIG. 15
	connections.

5.Remove the condenser.

6.Re-install the components by referring to notes.

(See Fig. 15)

13. EVAPORATOR

1.Remove the cabinet. (Refer to section 2)

2.Discharge the refrigerant completely.

3.Remove the 2 screws which fasten the evaporator at the left side and the right side.

4.Move the evaporator sideward carefully and then unbraze the interconnecting tube at the evaporator connectors.

5.Remove the evaporator.

6.Re-install the components by referring to notes. (See Fig. 16)

Cool
Energy
Saver
Fan
MODE	Timer	'F
	TIMER	TEMP
		FAN
		SPEED

POWER

FIG. 16

14. CAPILLARY TUBE

1.Remove the cabinet. (Refer to section 2)

2.After discharging the refrigerant completely, unbraze the interconnecting tube at the capillary tube.

3.Remove the capillary tube.

4.Re-install the components by referring to notes.

Service Manual 13