Friedrich US12C10, US12C30, US14C30, US10C30, US10C10, US08C10 Power Cord, Electronic Control Board

www.sylvane.com 1-800-934-9194

2.3.4 POWER CORD

1.Remove the control box. (Refer to section 2.1.3)

2.Unfold the control box. (Refer to section 2.3.3)

3.Disconnect the grounding screw from the Base pan.

4.Disconnect 2 receptacles.

5.Remove a screw which fastens the clip cord.

6.Pull the power cord. (See Fig. 13)

7.Re-install the components by referring to the

removal procedure, above.

(Use only one ground-marked hole, , for ground connection.)

8.If the supply cord of this appliance is damaged, it must be replaced with the factory-authorized and specified cord.

Figure 13

2.3.5 ELECTRONIC CONTROL BOARD

1.Remove the control box. (Refer to section 2.1.3)

2.Unfold the control box. (Refer to section 2.3.3)

3.Disconnect all the leads of Electronic control board terminals.

4.Remove the Electronic control board. (See Fig. 14)

5.Re-install the components by referring to the removal procedures, above.

Figure 14

—13—