TO SET THE TIMER
NOTE: You can set the START and STOP times a minimum of one hour apart, and a maximum of 23 hours apart.
10TIMER START - Press Startto view the current start time for cool- ing. Continue pressing the START button until you arrive at the start time you desire. The start time for cooling will then be set.
11TIMER STOP - Press the Stop button. Continue pressing the STOP button until you arrive at the stop time you desire. The stop time for cooling will then be set.
12TIMER ON / OFF - Press the ON/OFF button (under Timer Operation) to activate (light on) or deactivate (light off) the timer. Once the on and off times have been selected, they will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the Set Hour. function must be reset or the Timer On/Off function will not work.
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.
Temperature
Cooler 
Warmer
Cool | Power | Heat | |
|
| ||
Fan | Fan |
| Money |
Only | Speed | Saver® | |
Timer Operation |
|
| |
On/Off | Start | Stop | Set Hr. |
FIGURE 3
WY/WE
HOW TO CLEAN THE AIR fiLTER
Your Friedrich room air conditioner is equipped with a Permafoam reusable air filter which is not affected by washing. The filter serves to remove dust, pollen, and other impurities from the air.
KEEP THE FILTER CLEAN - A clogged, dirty fi lter will reduce the operating efficiency of your unit and contribute to frosting of the indoor coil. Be sure to check the filter at least once a month, more frequently if conditions warrant. The filter check procedure is easy, due to the unique design of the Friedrich
DECORATIVE FRONT.
FILTER ACCESS - Remove the INTAKE GRILLE from the DECORATIVE FRONT frame by grasping it at the upper right and left side corners. Pull out until the GRILLE is released from the upper retaining snaps. Tilt down toward you, lift up and out of the bottom retaining snaps. This will expose the filter. Remove the filter by pulling it toward you. Wash the filter in hot, soapy water, rinse, squeeze lightly to remove excess water, shake dry - do not twist - and replace in the unit on the two support hangers. Replace the INTAKE GRILLE by positioning the bottom of the GRILLE into the bottom retaining snaps. Tilt the front up and away from you. Press in lightly on top and the GRILLE will position itself into the upper retaining snaps.
FILTER |
INTAKE GRILLE |
FIGURE 4 |
6
