OPERATING INSTRUCTIONS
Status Indicator Lights
The WASHING light comes on at the beginning of cycle and remains on until the end of the main wash.
The DRYING light indicates the drying portion of the cycle. The light will come on when either drying option is selected.
When the SANITIZE option is selected, the SANITIZED light will glow when the SANITIZE cycle is finished and remain on until the door is opened. If the dishwasher did not properly sanitize the dishes, the light will not come on. This can happen if the cycle is interrupted or if incoming water temperture is below 120oF.
The CLEAN light will come on at end of cycle and remain on until door is opened.
The RINSING AGENT LOW light, Located near the Rinse Only Pad, comes on at the end of a cleaning cycle when the rinse agent reservoir is low. The light will remain on through 5 successive cycles or until the reservoir is filled.
In the unlikely event the dishwasher malfunctions, the indicator may display one of the following codes "Er", "uF", "uo", or "CE". If one of these codes are displayed
contact the Frigidaire Customer Care Center at 1-
locating an authorized service technician, if needed.
PF……………… | Appears in window when |
| dishwasher is first installed, or |
| when power has been |
| interrupted. |
| and NO HEAT DRY indicator |
| lights will also flash. To clear, |
| touch START/CANCEL pad. |
Number of delay start hours. | |
| The last hour will count down |
| in minutes. |
CL……………… | Close dishwasher door. The |
| status indicator lights will also |
| flash to indicate current cycle |
| status. |
HO or Hd…..… | Indicate a water heat delay. |
MINUTES…...… | Number of minutes left in cycle |
| |
| 99 minutes, a small plus sign |
| will appear beside the number |
| of minutes and remain on until |
| time counts below 99. |
NOTE
The time remaining could suddenly increase or drop several minutes. This means the Smart Sensor has checked the soil level and determined if additional water
fills are needed or if water fills can be deleted.
8
