Air Conditioner Features
(continued)
CHECK FILTER FEATURE:LIGHT OnCLEAN AIR FEATURE (on some models):
DO THIS:
PRESS
CLEAN AIR
BUTTON
| YOU WILL SEE: | DO THIS: |
AFTER CLEANING
PRESS CHECK FILTER BUTTON
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the “ Check Filter ” button and the light will go off.
YOU WILL SEE: | LIGHT On | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: When this feature is “ON”, the electronic air purifier is energized to remove pollen and impurities from the air. To cancel this feature, press the Clean Air button (the LIGHT will turn off).
REMOTE SENSING/FOLLOW ME FEATURE
| (on some models) : | LIGHT pulsing On & Off intermittently. |
|
| SET TEMP. |
|
ON |
|
| F |
OFF |
|
|
|
FAN SPEED |
|
| |
Mode |
|
| Fan |
Energy Saver |
|
| Timer |
Clean Air |
|
| Cancel |
Follow Me | Reset | Lock | Clock |
Sleep | Light |
| |
DO THIS:
PRESS REMOTE SENSING/FOLLOW ME
BUTTON ON
|
| SET TEMP. |
|
ON |
|
| F |
OFF |
|
|
|
FAN SPEED |
|
| |
Mode |
|
| Fan |
Energy Saver |
|
| Timer |
Clean Air |
|
| Cancel |
Follow Me | Reset | Lock | Clock |
Sleep | Light |
| |
| NOTE: Unit display shows “set” temperature | NOTE: Remote display |
| is actual temperature at |
| remote control only |
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the
buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. It will con- tinue to send this signal until the feature is deactivated by pressing the remote sensing button. If the unit does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY. The unit display indicates the set temperature.
9
