Frigidaire 297298700, FPRH19D7LF Door Removal Instructions, Door Handle Mounting Instructions

DOOR REMOVAL INSTRUCTIONS

Door Handle Mounting Instructions

1.Remove handle from carton and any other protective packaging.

2.Position refrigerator handle end caps over upper and lower pre-installed shoulder bolts (A) that are fastened into door, ensuring the holes for the set screws are facing towards the outside of door if a single unit installation or the freezer door (if installing the matching freezer)

3.While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench.

4.Repeat steps 2 and 3 to install freezer handle (if installing the matching freezer). Ensure the holes for the set screws are facing towards the refrigerator door.

NOTE

All set screws should be tightened and sub-flush (Allen set screw should be seated just below the surface of the end cap) of handle end cap. The end caps should be drawn tight to refrigerator door with no gaps.

A

B

Single Unit Installation

Kick Plate Removal

To remove the kick plate, use a Phillips head screwdriver and remove the two screws holding the kick plate to the cabinet. Then pull the kick plate away from the unit.

Leveling

The refrigerator must have all bottom corners resting firmly on a solid floor.

The floor must be strong enough to support a fully loaded refrigerator.

It is VERY IMPORTANT for your refrigerator to be level in order to function properly. If the refrigerator is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost or moisture problems.

Leveling instructions continued on next page.

Matching Refrigerator and Freezer Door Handle

Installation

Remove Screws

Kick Plate Removal

6