Frigidaire 316000291 (9902) Changing Oven Light, Avoid Service Checklist, Occurrence, some models

Changing Oven Light		Be sure the range is unplugged and all parts are COOL before
(some models)	replacing the surface or oven lights. Wear a leather-faced glove for protection
	against possible broken glass.

To Change the Oven Light (some models)

On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven.

To replace the oven light:

1.Turn electrical power off at the main source or unplug the range.

2.Replace bulb with a new 40 watt appliance bulb.

3.Turn power back on again at the main source (or plug the range back in).

4.The clock(if equipped) will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Owner's Guide.

Avoid Service Checklist

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE	POSSIBLE CAUSE/SOLUTION
Range is not level.	Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust
	leveling legs at base of range until the rack is level. When range is level, cooktop may
	appear out of alignment if countertop is not level.
	Weak, unstable floor. Be sure floor is level and can adequately support range. Contact
	a carpenter to correct sagging or sloping floor.
	Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets
	are square and have sufficient room for range clearance.

Cannot move appliance easily. Appliance Cabinets not square or are built in too tight. Contact a cabinet maker to correct the

must be accessible for service.	problem.
	Contact builder or installer to make appliance accessible.
	Carpeting interferes with range. Provide sufficient space so range can be lifted over
	carpet.
	Gas line is hard-plumbed. Have a flexible A.G.A./C.G.A. approved metal appliance
	connector installed.
Surface burners do not light.	Surface Control knob has not been completely turned to LITE. Push in and turn the
	Surface Control knob to LITE until burner ignites and then turn control knob to desired
	flame size.
	Burner ports are clogged. Clean burners. See "To Clean the Contoured Well Areas,
	Burner Cap Assembly, Trim Ring (some models), Burner Pan (some models) and Burner
	Base" under General Cleaning. With the burner off, clean ports with a small-gauge
	wire or needle.
	Range power cord is disconnected from outlet (Electric Ignition Models only). Be sure
	cord is securely plugged into the outlet.
	Electrical power outage (electric ignition models only). Burners can be lit manually. See
	Setting Surface Controls in this Owner's Guide.

14