INSTALLATION INSTRUCTIONS
Rotate 180̊
Fan Blade Openings
Figure 9A
Change the position of wire to left side hole
(B)(A)
Figure 9B
Hood Fan Wire
Figure 9C
Figure 10A
(C)VERTICAL EXHAUST: OUTSIDE VENTILATION
1.Remove and save 3 screws from back edge and 5 screws from the top of the Fan Cover Bracket to use at Step 5. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket as shown in Figure 11.
2.Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 12. CAUTION: Do not pull or stretch Hood Fan
Wire.
3.Rotate the Hood Fan Unit 90˚ so that the Fan Blade Openings are facing the top of the oven. See Figure 13 on page 6. Replace Hood Fan Unit into the oven. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. Put the lead wire into Wire Box.
4.Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan Cover Bracket. Make sure the fan blades are visible through the top openings in the oven before proceeding. See Figure 14 on page 6.
5.Attach the Fan Cover Bracket to unit with the 3 screws from back edge and 5 screws from the top of the Fan Cover Bracket, which were removed at Step 1 above. See Figure 14 on page 6. The Hood Fan Unit is now rotated for vertical exhaust operation.
6.Attach the Exhaust Damper Assembly to the fan cover bracket on the top of the outercase cabinet after mounting the oven. To attach the Exhaust Damper Assembly, refer to MOUNTING OVEN TO THE WALL, See Figure 20 on page 7 and TOP CABINET TEMPLATE.
Fan Cover Bracket
Exhaust Damper |
| Figure 11 |
Assembly |
|
|
Fan Cover Bracket |
|
|
| Wall Side | Hood Fan Unit |
Apply Rear Cushion |
| |
| Hood Fan Wire | |
after Exhaust Damper |
| |
|
| |
Assembly is screwed |
|
|
to wall. | Rear Cushion |
|
|
| |
Save the assembly for |
|
|
future instructions. |
|
|
Oven Rear Side |
|
|
Figure 10B |
| Figure 12 |
5 | E |