INSTALLATION INSTRUCTIONS
Over The Range Microwave Oven
BEFORE YOU BEGIN | Read these instructions completely and carefully. | ||||
|
|
| |||
• | IMPORTANT | Save these instructions for local | • Proper installation is the responsibility of the installer. | ||
| inspector’s use. |
| • Product failure due to improper installation is not covered | ||
|
|
|
| ||
• | IMPORTANT | Observe all governing codes and | under the Warranty. | ||
| coordinates. |
| • Please read all instructions thoroughly before installing | ||
• | NOTE TO INSTALLER – Be sure to leave these | the Over the Range Microwave Oven. Two people are | |||
| instructions with the Consumer. |
| recommended to install this product. | ||
|
|
| |||
• | NOTE TO CONSUMER – Keep these instructions for | • If a new electrical outlet is required, its installation should | |||
be completed by a qualified electrician before the Over the | |||||
| future reference. |
| |||
|
| Range Microwave Oven is installed. See 3 ELECTRICAL | |||
• | SKILL LEVEL – Installation of this appliance requires | ||||
GROUNDING INSTRUCTIONS on page 2. | |||||
| basic mechanical and electrical skills. |
|
| ||
|
|
|
|
|
1 MOUNTING SPACE
This Over the Range Microwave Oven requires a mounting space on a wall as shown in Figure 1. It is designed to be used with standard 12" wall cabinets.
2 WALL CONSTRUCTION
This Over the Range Microwave Oven should be mounted against and supported by a flat vertical wall. The wall must be flat for proper installation. If the wall is not flat, use spacers to fill in the gaps. Wall construction should be a minimum of 2" x 4" wood studding and 3/8" or more thick dry wall or plaster/lath. The mounting surfaces must be capable of supporting weight of 110
12"
30" 15.5"
Backsplash At least 2"
30" or more
from cooking
surface
all items which would normally be stored in the top cabinet above the unit.
The unit should be attached to a minimum of one 2" x 4" wall stud.
To find the location of the studs, one of the following methods may be used:
A.Use a stud finder, a magnetic device which locates the nails in the stud.
B.Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate stud location.
66" or more
from floor
Figure 1
The center of the stud can be located by probing the wall with a small nail to find the edges of the stud and then placing a mark halfway between the edges. The center of any adjacent studs will normally be 16" or 24" to either side of this mark.
NEED HELP?
For customers in the United States and Canada United States:
Canada:
READ CAREFULLY. KEEP THESE INSTRUCTIONS.
316495060