30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
United States
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Canada
1. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b.
c.Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must be solid and level.
FRONT | TYPICAL CABINET INSTALLATION | SIDE | |
VIEW | |||
VIEW |
| ||
|
| ||
| 1/8 |
|
*30" minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet; or 24 " minimum when bottom of wood or metal cabinet is protected by not less than ¼" flame retardant millboard covered with not less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. The minimum clearance is 0" for the rear of the range. Follow all dimension requirements provided above to prevent property damage, potential fire hazard, and incorrect countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units to eliminate the possibility of cabinets catching on fire, or personal burns from reaching for the cabinets over the heated units. If cabinet storage is to be provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" beyond the bottom of the cabinets.
Important Notes to the Installer
1.Read all instructions contained in these installation instructions before installing the appliance.
2.Remove all packing material before connecting the electrical supply to the appliance.
3.Observe all governing codes and ordinances.
4.Be sure to leave these instructions with the consumer.
FRONT |
VIEW |
BACK |
VIEW |
All dimensions for electrical outlet location are maximum.
| Cubed area shows |
Terminal | where the electrical |
Block | outlet must be |
Location | installed for the |
| range to be flush to |
| the wall. |
Wall
Edge
Important Note to the Consumer
Keep these instructions with your Use and Care Guide for future reference.
Printed in United States | 318201724 (0904) Rev. A |
1