Frigidaire 318201822 installation instructions Warmer Drawer Dimensions Stand Alone Installation

WARMER DRAWER INSTALLATION INSTRUCTIONS

Canada

INSTALLATION AND SERVICE MUST BE PERFORMED

BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

WARNING FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

United States

GENERAL INFORMATION - The Warmer Drawer can be used as a stand alone appliance or as a combination Warmer Drawer with a built-in oven mounted above.

IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface must be capable of supporting 100 pounds (45,4 Kg).

Warmer Drawer Dimensions

NOTE: A 60" (152,4 cm) long cable is supplied with the Warmer Drawer.

Stand Alone Installation

C	60" (152,4 cm)
	Cord

BWarmer Drawer

A

								Warmer Drawer
								Cutout
					F
	D
						E
Minimum distance		to
floor 4½" (11,4 cm)
							FLOOR
				A. HEIGHT				B. WIDTH	C. Depth
27" Models			11 ¼" (28,6 cm)					27" (68,6 cm)	23 3/8" (59,4 cm)
30" Models			11 ¼" (28,6 cm)					30" (76,2 cm)	23 3/8" (59,4 cm)
				D. cutout				E. cutout	F. cutout
					height			width	depth
27" Models - Min.				9 7/8" (25,1 cm)				25 ½" (64,8 cm)	23 5/8" (60 cm)
Max.				10 ¼" (26 cm)				25 ¾" (65,4 cm)	24" (61 cm)
30" Models - Min.				9 7/8" (25,1 cm)				28 ½" (72,4 cm)	23 5/8" (60 cm)
Max.				10 ¼" (26 cm)				28 ¾" (73 cm)	24" (61 cm)

IMPORTANT: The Warmer Drawer runs off a single phase three-wire 120 volt, 60 hertz, AC only electrical supply with ground.

Combination Warmer Drawer / 27" (68,6 cm) or

30" (76,2 cm) Built-in Oven Installation

Caution: Two 3" (7,6 cm) wide X ¾" (1,9 cm) thick planks have to be installed and they should be able to support 200 pounds (90,7 Kg).

		of oven cutout
29	1/16"	Bottom
(73,8 cm)

H* =11 7/8" (30,2 cm) Min. is the space between the bottom of the drawer cutout and the bottom of the

oven cutout. This is a critical dimension and must be provided. J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven can be lower than warmer drawer cutout.

	A. HEIGHT	B. WIDTH	C. Depth
27" Models	11 ¼" (28,6 cm)	27" (68,6 cm)	23 3/8" (59,4 cm)
30" Models	11 ¼" (28,6 cm)	30" (76,2 cm)	23 3/8" (59,4 cm)
	D. cutout	E. cutout	F. cutout	G. HEIGHT
	height	width	depth
27" - Min.	9 7/8" (25,1 cm)	25 ½" (64,8 cm)	23 5/8" (60 cm)	2" (5,1 cm)
Max.	10 ¼" (26 cm)	25 ¾" (65.4 cm)	24" (61 cm)	Depends on critical
				dimension H
30" - Min.	9 7/8" (25,1 cm)	28 ½" (72,4 cm)	23 5/8" (60 cm)	2" (5,1 cm)
Max.	10 ¼" (26 cm)	28 ¾" (73 cm)	24" (61 cm)	Depends on critical
				dimension H

*Note: It is also possible to install this warmer drawer in a height opening of 9¼" (23,5 cm). Please refer to page 3 for complete instructions.

Printed in United States 1

P/N 318201822 (0901) Rev. A

English – pages 1-4

Español – páginas 5-8

Français – pages 9-12