Frigidaire 318201822 Important Notes to the Installer, Important Note to the Consumer

WARMER DRAWER INSTALLATION INSTRUCTIONS

Important Notes to the Installer

1.Read all the instructions contained in these installation instructions before installing appliance.

2.Remove all packing material from the appliance before connecting the electrical supply.

3.Observe all governing codes and ordinances.

4.Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions for future reference.

IMPORTANT SAFETY INSTRUCTIONS

•Be sure your appliance is installed and plugged into a 120 Volt grounded outlet.

•This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No. 70—latest edition in the United States, or CSA C22.1, Part 1 in Canada, and local code requirements.

Tools You Will Need

1- Phillips® Screwdriver; 2- Pencil; 3- Ruler or Tape Measure and Straight-edge; 4- Hand Saw or Saber Saw; 5- Level.

Warmer Drawer Installation

1.Locate the 2 anti-tip brackets supplied as shown on figure 1.

c/c 25 5/16"

(64,3 cm)

24" (61 cm) Max.

23 5/8" (60 cm) Min.

c/c 12 21/32"

(32,1 cm)

2.Slide the drawer into the cutout opening until the front frame of the drawer is flush against the cabinet. Be careful not to pinch the electrical cord.

3.Remove the drawer as instructed in the Use & Care Guide and secure the drawer housing to the cabinet using the 2 black head screws (10-16 X ¾") supplied (see Figure 2). Do not overtighten screws.

4.The 60" (152,4 cm) appliance power cord can now be connected into the 120 Volt outlet.

5.Proceed with mounting the built-in oven above the drawer (if applicable). Follow the installation instructions provided with the built-in oven. Make sure to use the anti-tip brackets supplied with the built-in oven.

Use screws
supplied to attach
drawer to front of	Figure 2
cabinet.

Electrical connection

IMPORTANT Please read carefully.

For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped with a

3-prong (grounding) plug which mates with a standard 3-prong grounding wall receptacle to minimize the possibility of electric shock hazard from the appliance.

The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded.

Where a standard 2-prong wall receptacle is installed, it is the personal responsibility and obligation of the consumer to have it replaced by a properly grounded 3-prong wall receptacle.

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

Disconnect electrical supply cord from wall receptacle before servicing cooktop.

Preferred Method
Grounding type	Do not, under any
	circumstances, cut,
wall receptacle
	remove, or bypass
	the grounding
	prong.

Power supply cord with

3-prong grounding plug.

2