Setting Warm & Serve Drawer Controls (some models)
Warm & Serve Drawer Temperature Selection | Warm & Serve Drawer | |||||
Recommended Warm & Serve Drawer settings table is shown aside. If a particular | ||||||
recommended Food Settings | ||||||
food is not listed, start with the MED setting. If more crispness is desired, remove | ||||||
Table |
| |||||
the lid or aluminum foil from the food. Most foods can be kept at serving |
| |||||
|
| |||||
temperatures on the MED setting. When a combination of foods are to be kept | Food Item | Setting | ||||
warm (for instance, meat with 2 vegetables and rolls), use the HI setting. To avoid | ||||||
Bacon | HI | |||||
heat loss, do not open the Warm & Serve Drawer while in use. | ||||||
Hamburger Patties | HI | |||||
|
|
|
| |||
To Set the Warm & Serve Drawer Controls: | Poultry | HI | ||||
Pork Chops | HI | |||||
The control and indicator lights for the Warm & Serve Drawer features are located | ||||||
Fried Foods | HI | |||||
on the control panel. The temperatures are approximate, and are designated by HI | ||||||
Pizza | HI | |||||
(high), MED (medium) and LO (low). |
| |||||
| Gravies | MED | ||||
|
|
|
| |||
1. Touch the | pad at the Warm & Serve Drawer control position (see Figure | Casseroles | MED | |||
Eggs | MED | |||||
4). The Warm & Serve Drawer indicator light will flash. Note: If no further pads | ||||||
Roasts (Beef, Pork, Lamb) MED | ||||||
are touched within 25 seconds the request to power the Warm & Serve Drawer | ||||||
Vegetables | MED | |||||
ON will clear. |
|
|
| |||
|
|
| Biscuits | MED | ||
|
|
|
| |||
2. Set the desired power level. Touch | once to turn ON the power level for | Rolls, hard | MED | |||
Pastries | MED | |||||
|
|
|
| |||
HI (see Figure 1) or | to turn ON the power level for LO (see Figure 3). The | Rolls (soft) | LO | |||
Empty Dinner Plates | LO | |||||
Warm & Serve Drawer indicator light located beside the 
pad will turn ON steady.
3. Each touch of the 
or 
pads will decrease or increase through 6 power levels from HI
(see Figure 1) to MED (see Figure 2) to LO (see Figure 3). Note: For best results, preheat the Warm & Serve Drawer before adding the food . An empty drawer will preheat in approximately 15 minutes.
4. When the food is ready for removal, touch the
pad once to turn the Warm & Serve
Drawer OFF. The Warm & Serve Drawer indicator light will turn OFF.
Note: The Warm & Serve drawer is equipped |
|
|
|
|
with a catch which may require extra force when | Figure 1 | Figure 2 | Figure 3 | Figure 4 |
opening and closing the drawer. |
Setting Oven Controls
Refer to the Electronic Oven Control Guide for oven settings.
12
