Dishwasher Dispenser & Detergents (continued)
Rinse Aid
Rinse aid greatly improves drying and reduces water spots and filming. Water “sheets” off dishes rather than forming water droplets that cling and leave spots.
A dispenser, located next to the detergent cup, automatically releases a measured amount of rinse aid during the last rinse. If spotting and poor drying are problems, increase the amount of rinse aid dispensed by rotating the dial to a higher number. The dial is located under the dispenser cap. The indicator will be dark when full and will show clear when it is time to refill.
To add liquid rinse aid, turn dispenser cap 1/4 turn counterclockwise and lift out. Pour in rinse aid until liquid touches the indicated fill level. Replace cap.
Do not overfill since this can cause oversudsing. Wipe up any spills with a damp cloth.
The dispenser holds enough for 35 to 140 washes, depending on setting.
Dispenser Opening | Indicator | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Adjustable setting
Dispenser Cap
Factors Affecting
Performance
Water Pressure
The hot water line to dishwasher must provide water pressure between 20 and 120 psi.
Low water pressure may occur when laundry or showers are in operation. Wait until water use is reduced before starting dishwasher.
Water Temperature
Hot water is needed for best dishwashing and drying results. Water entering dishwasher should be at least 120°F (49°C) to give satisfactory results.
To check water temperature entering dishwasher:
•Turn on hot water faucet nearest dishwasher for several minutes to clear cool water from pipes.
•Hold a candy or meat thermometer in stream of water to check the temperature.
•If temperature is below 120°F (49°C), have a qualified person raise the hot water heater thermostat setting.
Important: Before starting a cycle, run hot water to clear cool water from pipe.
11
