Changing Color Panels
Some models come with reversible door panel inserts which offer three decorative colors. The panels are separated by a divider trim strip.
Depending on the model, either or both panels may be changed.
To change the color panel:
Note: If your unit does not have a divider trim strip, exceptions to these directions are noted after the individual steps.
1.Remove
Bottom edge of door
Bottom trim
2.With one hand on the upper panel and one hand on the lower panel, gently slide the panel assembly down until the entire assembly rests on the floor. Note: Slide color panel(s) down about 1/2" on units without a divider trim strip.
Cut Hazard
Metal door panels are sharp and should be handled with care. Wear gloves to protect hands.
Failure to do so can result in injury.
3.Grasp top of upper panel(s) and pull up until clear of divider trim strip. Then bow panel(s) until clear of side trim. Remove panel(s) but do not remove spacer. Note: To complete color panel change on units without a divider trim strip, proceed with steps 5, 6 and 8.
Divider trim strip | Spacer |
4.Check to see if spacer has remained in the channel of the divider trim strip. If it has not, replace securely in channel. It may be helpful to gently push in on divider trim strip while reinserting the spacer.
14
