Frigidaire Air Conditioner manual Operation of Current Device, For Your Safety, Prevent Accidents

Models: Air Conditioner

1 33
Download 33 pages 638 b
Page 2
Image 2

This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.

The power supply cord with

this air conditioner contains a current

detection device designed to reduce the risk of fire.

Please refer to the section 'Operation of Current Device'for details.

In the event that the power supply cord is damaged, it cannot be repaired. It must be

replaced with a cord from the product manufacturer.

Avoid fire hazard or electric shock. Do not

use an extension cord or an adaptor plug. Do

not remove any prong from the power cord.

For Your Safety

DO not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read product labels for flammability and other warnings.

Prevent Accidents

To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner, follow basic precautions, including the following:

Be sure the electrical service is adequate for the model you have chosen. This information can be found on the serial plate, which is located on the side of the cabinet and behind the grille.

If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included, remove the screen completely before installation.

Be sure the air conditioner has been securely and correctly installed according to the separate installation instructions provided with this manual. Save this manual and the installation instructions for possible future use in removing or reinstalling this unit.

When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front and rear coils.

 

 

 

 

 

Electrical Information

 

 

 

 

The complete electrical rating of your new room air conditioner is stated on the serial plate.

 

 

 

Refer to the rating when checking the electrical requirements.

 

 

Grounding

Prong

.

proper grounding is important. The power cord is equipped with a three-prong grounding

 

Be sure the air conditioner

is properly grounded.

To minimize

shock and fire hazards,

__/--_

_,nonot, under

any

 

plugfor protectionagainstshockhazards.

 

 

23OV /

circumstances,

cut,

'

Your air conditioner must

be used in a properly

grounded wall

receptacle, ff the wall

 

 

 

 

receptacle you intend to use is not adequately grounded or protected by a time delay fuse

grounding prong.Do not run air conditioner without outside protective cover in place. This could result in

_o remove or bypass the . or circuit breaker, have a qualified electrician install the proper receptacle. mechanical damage within the air conditioner.

Do not use an extension cord or an adapter plug,

READ THIS SECTION BEFORE ATTEHPTING TO OPERATE AIR CONDITIONER.

Unit must be upright for one hour prior to operating.

Operation of Current Device

Plug in & press RESET

The power supply cord contains a current device that senses damage to the power cord. To test your power supply cord do the following:

1.Plug in the Air Conditioner.

2.The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will notice a click as the RESET button pops out.

3.Press the RESET button, Again you will notice a click as the button engages.

4.The power supply cord is now supplying electricity to the unit, (On some products this is also indi- cated by a light on the plug head),

. Do not use this device to turn the unit on or off.

Always make sure the RESETbutton is pushed in for correct operation.

The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or it cannot be reset. A new one can be obtained from the product manufacturer.

. If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained from the product manufacturer.

2

©2009

Electrolux Home Products, Inc.

All rights reserved.

 

 

 

Page 2
Image 2
Frigidaire Air Conditioner manual Operation of Current Device, For Your Safety, Prevent Accidents, Electrical Information