YOU WILL SEE:
DOTHIS:
PRESS FILTER RESET BUTTON
tamp/timer
rem£te
sensmg
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) Will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off.
REMOTE SENSING FEATURE
(on some models):
LIGHT pulsing ( On & Off intermittently ).
o
Lamp/timer
TEHP/TTME]_
© | © | © |
|
| remqte |
|
| sensmg | |||
5 | © | Q |
| SENSING | |
sleep | _ | _mer | I | DO THIS: | |
|
|
| PRESS | REMOTE | |
|
|
|
| START | BUTTON |
FRIGIDAIRE | NOTE: Unit display | shows the set temperature |
|
NOTE: Remote display is actual temperature at remote control only
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use the" A V "buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control wilt pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal, it will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button, if the unit does not receive the remote sensing signal during any 3 minute interval, the unit wilt beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the unit.
HEATING FEATURE(on some models): | YOU WILL SEE: |
tamp/timer
auto
[] hi
mad
lo
heat
[] cool
energy saver
DO THIS:
PRESS
IMODE BUTTON
SELECT HEAT
tamp/timer
adto
[] hi
mad
lo
[] heat cool
energy surer
fan omy
Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models), Timer, or Sleep Modes. When in the "Heat" mode,the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55 °F(13 °C) and 80 °F(27 °C). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air.
@2009 Electrolux Home Products, Inc. | All rights reserved. |
/
