WALL SLEEVE INSTALLATION INSTRUCTIONS FOR
FRIGIDAIRE
THRU-THE WALL AIR CONDITIONERS
READ AND SAVE THESE INSTRUCTIONS
Check the contents of the accessories supplied with our air conditioner as shown below:
To avoid risk of personal injury, property damage, or product damage duetotheweightofthisdeviceand
sharp edges that may be exposed:
•Air conditioners covered in this manual pose an excessive weight hazard. Twoormorepeopleare needed to moveand install theunit.
To prevent injury or strain, use proper lifting and carrying techniques when moving unit.
•Carefully inspect location where air conditionerwill be installed. Be sure it will support theweight of the unit overan extended period of time.
•Handle air conditioner with care. Wearprotectivc gloves whenever liftingor carrying theunit. AVOID the sharp metalfins of front and rearcoils.
•Make sure air conditioner does not fall durin( installation.
For New Construction install Frigidaire Wall Sleeve (Part EA108T).
Remove old air conditionerand inspect sleeve forthe following:
condensate to drain from the rear of the sleeve.
Check against Fig.A.
1/4" to 5/16"
REAR k | Wall Sleeve | _ | _E | FRONT |
|
|
| ||
|
|
| UNIT | VEL |
|
|
|
|
Number |
| Part | name | QTY. | |
1 | Top/Bottom | Trim | Frame | 2 | |
2 | Side Trim Frame |
| 2 | ||
3 | Plastic | Mesh |
|
| 1 |
4 | Tapered | Spacer | Block Board | 2 | |
5 | Tapered | Spacer | Block | 1 | |
6 | Vertical | Foam |
| 2 | |
7 | Horizontal | Foam |
| 2 | |
8 | Vertical | Trim | Foam | 2 | |
9 | Horizontal | Trim | Foam | 2 | |
10 | Screw |
|
|
| 4 |
11 | Washer |
|
|
| 4 |
Fig. A
If the installation and slope are suspect, then removal
and correct installation of a Frigidaire WallSleeve
(Part EA108T), is recommended.
P/N: