INSTALLATION
8.If you wish to keep the unit beoperatedathigher
performance state, remove the steel rear grille and
attach the plastic rear grille. The plastic grille will
minimize the recirculation of hot discharge air.
Plastic rear grille
Steel rear grille
Fig. F
9.If thedepth ofyour existingwall sleeve is less than or equal to 20", skip to step 11. Otherwise, cut the
baffles and the support blocksaccording to length"A" in thetable below.
Depth | "D"of | the |
|
existing | wall |
| Length "A" |
sleeve | (inches) | (inches) | |
20<D_<20% |
|
| |
20%<D..<2 | I_ | ||
213/4<D_<24 |
| 4 | |
11.lnstallthe new unit intothe wall sleeve.
12.To assemble trim, snapthe tab ofeach piece into the slot of the other piece asshown below. Remove
the backing from the trim foamand stick thattothe inside of the trim as shown below.
HorizontalVertical
rm rmoa
Assemble Trim | Attach Trim Foam |
Fig. 1
12.Slide trim over thefront ofthe airconditioner until trim is flush with sleeve as shown below.
Fig. J
NOTE: Be sure to route the cord through the trim frame before placing the trim frameon the unit.
10.Remove the backing from the support blocks and attach them to the inside of the wall sleeve as shown
FIG 14. Slide the baffle intoslotsofthesupport blocks.
I | /" | .................................... | " | 7 | " |
Wall __ |
|
| i_i' i | BPerc_dBtPaaSer | |
Sleeve | " | _ | ""'_"i" _ |
|
|
W__ |
|
| _ | Block | |
|
|
| |||
Fig. H
•Air conditioners covered in this manual pose an excessive weight hazard. Two or more people arc needed to moveand install theunit. To prevent injur_
orstrain, useproperlifting and carrying technique, _
when moving unit.
•When handling the air conditioner, be carefult(
avoid cuts from sharp metal fins onfrontand rear coils.
•Make sure air conditioner does not fall durin( removal.
