Care and Cleaning (continued)
Property Damage Hazard
Freezing temperatures may cause water lines to rupture. Be sure all supply lines to and circulating lines within dishwasher are protected.
Failure to do so could result in property damage.
Winterizing
A dishwasher left in an unheated place should be protected from freezing. Have a qualified person do the following:
To Disconnect Service:
1.Turn off electrical power to the dishwasher at the supply source by removing fuses or tripping circuit breaker.
2.Shut off water supply.
3.Place a pan under the inlet valve. Disconnect water line from inlet valve and drain into pan.
4.Disconnect drain line from pump and drain water into pan.
Note: See Installation Instructions for more details.
To Restore Service:
1.Reconnect the water, drain, and electrical power supply.
2.Turn on water and electrical power supply.
3.Fill both detergent cups and run dishwasher through a POTS & PANS cycle.
4.Check connections to make sure they do not leak.
Note: See Installation Instructions for more details.
Cleaning the Spray Arm
The spray arm may need to be cleaned to insure that there are no clogs to the spray arm jets and bearings due to hard water chemicals.
To remove spray arm simply hold the spray arm in place and turn the retaining nut clockwise and pull up on the spray arm lifting off the shaft.
To clean the spray arm use warm soapy water using a soft brush to clean the jets and bearings.
To replace the spray arm simply set the spray arm on the shaft, take the retaining nut and turn it counter clockwise till it has locked into place.
14
