WARNING
Burn Hazard
Allow heating element to cool before cleaning the interior.
Failure to do so can result in burns.
Outside
Inside
damp cloth.
A glass trap located in the center of the filter is
designed to collect pieces of broken glass, straws, bones and pits. To remove items in
glass trap, grasp handle,
rotate, lift out, empty and replace.
NOTE
Hard water may cause lime deposit buildup on the interior of the dishwasher. For cleaning instructions see “Removing Spots and Film” section.
Overfill
•Clean occasionally with household cleaner containing vinegar or bleach to dissolve
any buildup.
• Overfill Protector should move up and down freely about one inch. If it does not move, lift and clean underneath.
Care of Drain Air Gap
If a drain air gap was installed for your
CARE AND CLEANING
CAUTION
Property Damage Hazard
Freezing temperatures may cause water lines to rupture. Be sure all supply lines to and circulating lines within dishwasher are protected.
Failure to do so could result in property damage.
Winterizing
A dishwasher left in an unheated place should be protected from freezing. Have a qualified person do the following:
To Disconnect Service:
1.Turn off electrical power to the dishwasher at the supply source by removing fuses or tripping circuit breaker.
2.Shut off water supply.
3.Place a pan under the inlet valve. Disconnect water line from inlet valve and drain into pan.
4.Disconnect drain line from pump and drain water into pan.
To Restore Service:
1.Reconnect the water, drain, and electrical power supply.
2.Turn on water and electrical power supply.
3.Fill both detergent cups and run dishwasher through a HEAVY WASH cycle.
4.Check connections to make sure they do not leak.
NOTE
See Installation Instructions for more details on disconnecting and restoring service to your dishwasher.
13