CARE & CLEANING
Cleaning recommendations for the ceramic glass cooktop (continued)
Plastic or foods with a high sugar content:
These types of soils need be removed immediately if spilled or melted onto the ceramic cooktop surface. Permanent damage (such as pitting of the cooktop surface) may occur if not removed immediately. After turning the surface elements OFF, use a razor blade scraper or a metal spatula with a mitt and scrape the soil from the hot surface (as illustrated). Allow the cooktop to cool, and use the same method for heavy or burned on soils.
Do not use the following on the ceramic glass cooktop:
•Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.
•Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.
•Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause Special
Caution for Aluminum Foil and Aluminum Cooking Utensils
•Aluminum foil
Use of aluminum foil will damage the cooktop. Do not use under any circumstances.
•Aluminum utensils
Since the melting point of aluminum is much lower than that of other metals, care must be taken when aluminum pots or pans are used. Pans that boil dry may permanently damage cooktop by breaking, fusing to, or marking it.
Care and cleaning of stainless steel
Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the General Care & Cleaning table for detailed cleaning instructions.
Removing and replacing the lift-off oven door
CAUTION
The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.
To Remove Oven Door:
1.Open oven door completely (horizontal with floor -
See Figure 1).
2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Figure 2). A tool such as a small
3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).
4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).
5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Figure 4).
To Replace Oven Door:
1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Figure 3).
2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Figure 4). The hook of the hinge arms must be fully seated onto the roller pins.
3.Fully open the oven door (horizontal with floor - See
Figure 1).
4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Figure 2) to the locked position.
5.Close the oven door.
Door Hinge locations
with oven door fully open
38
Figure 1
Figure 2
