AUTOMATIC ICE & WATER DISPENSER (CONTINUED)
Ice maker/dispenser tips
•If your refrigerator is not connected to a water supply or the water supply is turned off, turn off the ice maker by holding the On/Off
•The following sounds are normal when the ice maker is operating:
-Motor running
-Ice dropping into ice bin
-Water valve opening or closing
-Running water
•When dispensing ice, you will hear a snapping or clicking sound when the ice chute opens and closes.
•If you need a large quantity of ice at one time, it is best to get cubes directly from the ice bin.
•Ice cubes stored too long may develop an odd flavor. Empty the ice bin as explained below.
•When dispensing cubed ice, it is normal to have a small quantity of little pieces along with the whole cubes.
CAUTION
If the water supply to your refrigerator is softened, be sure the softener is properly maintained. Chemicals from a water softener can damage the ice maker.
Cleaning the ice maker
Clean the ice maker and ice bin at regular intervals, especially prior to vacation or moving.
1Turn off the ice maker.
2Remove the ice bin by pulling straight out.
3Empty and carefully clean the ice bin with
mild detergent. Do not use harsh or abrasive cleaners. Rinse with clear water.
4Allow the ice bin to dry completely before replacing in the freezer.
5 Replace the ice bin. | Removing Ice Bin |
Turn the ice maker on. |
|
Remove and empty the ice bin if:
•An extended power failure (one hour or longer) causes ice cubes in the ice bin to melt and freeze together, jamming the dispenser mechanism.
•You do not use the ice dispenser frequently. Ice cubes will freeze together in the bin, jamming the dispenser mechanism.
Remove the ice bin and shake to loosen the cubes or clean as explained above.
CAUTION
NEVER use an ice pick or similar sharp instrument to break up the ice. This could damage the ice bin and dispenser mechanism.
To loosen stuck ice, use warm water. Before replacing the ice bin, make sure it is completely dry.
IMPORTANT
When removing or replacing the ice bin, DO NOT rotate the auger in the ice bin. If the auger is accidentally rotated, you must realign the auger by turning it in 45 degree turns (see below) until the ice bin fits into place with the drive mechanism. If the auger is not properly aligned when replacing the ice bin, the refrigerator will not dispense ice. The fresh food door also may not close properly causing warm air to leak into the fresh food compartment.
Adjusting Ice Bin Auger
18
