Market Forge Industries ST-3E Preventive Maintenance, Cleaning The Generator, Trouble, Remedy

2. Remove the drain screen by lifting it off its mounting studs.

3. Wash cooking compartment interior using detergent and water. Rinse and dry thoroughly.

4. Remove the drip/spill trough.

5. Wash all removed pieces with a mild detergent, us- ing a brush, and rinse. These pieces can also be sent through a commercial automatic dish washing machine. Set these pieces aside for reassembly.

6. Replace the drip/spill trough.

TROUBLE-SHOOTING

TROUBLE			PROBABLE CAUSE					REMEDY
Generator doesn’t drain when the POW-		1.	Clogged or kinked generator drain				1.	Check to be sure that the generator
ER switch is pressed into the OFF posi-			line.					drain line is not kinked and is free
tion.		2.	Clogged generator drain hole.					of debris.
							2.	Check to be sure the generator
		3.	Faulty generator		solenoid	drain
			valve.					drain hole is free of debris.
							3.	Rebuild or replace generator sole-
								noid drain valve (P/n 08-5021).
CLEAN GENERATOR light stays	on	1.	Faulty or incorrectly set CLEAN				1.	Depress reset button on front pan-
after it has been cleaned (delimed) and			GENERATOR	thermostat.				el.
rinsed.		2.	Faulty CLEAN latching relay.				2.	Check/replace if necessary	(P/n
		3.	Wiring short.					08-6474).
							3.	Check wiring, at terminals.
		4.	Faulty Reset Switch
							4.	Check/Replace if necessary	(P/n
								08-6553)
Unit fails to hold.		1.	Faulty hold thermostat				1.	Replace (P/n 08-7521)
		2.	Faulty hold switch				2.	Replace (P/n 08-6550)
		3.	Faulty timer				3.	Check/replace control panel TIMER
								if necessary. (Mechanical 08-6464,
								Digital 08-6429)
			MAINTENANCE
GENERAL:				7.	Replace the drain screen inside the cavity.
This section contains both preventive and corrective				8.	Replace baffle, and pan supports into cooking cavity
maintenance information. Preventive maintenance may
					by hanging them on their mounting brackets.
be performed by maintenance personnel at the establish-
				9.	Leave door slightly ajar.
ment in which the cooker is installed. It is recommended
that user personnel never attempt to make repairs or
replacements to the equipment.	Assistance in service			PREVENTIVE MAINTENANCE:
methods or a current directory of authorized agencies				A good preventive maintenance program begins with
may be obtained from Market Forge Industries.				the daily cleaning procedure described above. Addition-
DAILY CLEANING:				al preventive maintenance operations are presented in
				this section.		In establishments which employ full-time
After each period of daily operation (more frequently as				maintenance personnel, the tasks described can be as-
required to maintain cleanliness) the cooker should be				signed to them.			For other installations, tasks requiring
thoroughly cleaned by completing the following steps:				mechanical or electrical experience must be performed
1. Remove the baffle, and left and right side pan sup-				by an authorized service agency.
port racks by lifting them up off their mounting brack-				CAUTION: Under no circumstances should hardware
ets.				(or parts) be replaced with a different size or type other

than as specified in the parts list. The hardware used in the cooker has been selected or designed specifically for its application and the use of other hardware may damage the equipment, present a safety hazard and will void any warranty.

The following sections set forth minimum preventive maintenance procedures which must be completed peri- odically to assure continued trouble-free operation.

CLEANING THE GENERATOR:

The Steam Tech Pressureless Steam Cooker has an au-

17