Mossewwd 27INST FR 04/09 | Frigidaire FGMO205KF, FGMO205KW instruction

27" Combination Installation

Built-In Microwave / Single Wall Oven / Warmer Drawer

27" Combination Installation Specifications

•Always consult local and national electric codes.

(Refer to product-specific electrical specifications on this page.)

•Minimum 23-5/8" deep cutout dimension is critical for proper combination installation, to ensure that each built-in product’s faceplate will fit flush against cabinet front.

•Bases must be level and cabinet front must be square.

•Minimum 4-1/2" required distance from bottom of Warmer Drawer cutout to floor.

•Respect critical dimensions as noted for proper installation of built-In products.

•Minimum 21" clearance needed for Wall Oven door depth when open.

27" Electric Single Wall Oven Specifications

•Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•For detailed electrical requirements, refer to model-specific product page and installation guide on web.

•To support Wall Oven when using in combination with Warmer Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base, capable of supporting 200 Lbs. Do NOT use full base, since planks are necessary to allow for proper air displacement.

27" Warmer Drawer Specifications

• Voltage Rating – 120V / 450W / 60 Hz / 15 Amps

27" Built-In Microwave Specifications

•For built-in installation, microwave MUST be installed with optional 27" Trim Kit which includes Bottom Duct Assembly – shipped in separate box, ordered by individual part number.

•Voltage Rating – 120V / 60 Hz / 15 or 20 Amps

•Connected Load (kW Rating) @ 120 Volts = 1.7 kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @ 120 Volts = 14.3 Amps

•Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

•Minimum 2-7/8" clearance required from bottom of Built-In Microwave cutout to top edge of Wall Oven’s faceplate, leaving a 2" visible gap between both product faceplates.

•Connected Load (kW Rating) @ 120 Volts = 0.5 kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @ 120V = 3.8 Amps

•Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

FRIGIDAIRE®

USA • 250 Bobby Jones Expressway • Martinez, GA 30907 • 1-800-FRIGIDAIRE • frigidaire.com

CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.caSpecifications subject to change.