BEFORE YOU CALL (Solutions to Common Problems)

IMPORTANT

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

Range is not level.

Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust

 

leveling legs at base of range until the rack is level. When range is level, cooktop may

 

appear out of alignment if countertop is not level.

 

Weak, unstable floor. Be sure floor is level and can adequately support range. If floor is

 

sagging or slopping, contact a carpenter to correct the situation.

 

Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are

 

square and have sufficient room for range clearance.

Cannot move

Cabinets not square or are built in too tight. Contact a cabinet maker to correct the problem.

appliance easily.

 

Contact builder or installer to make appliance accessible.

Appliance must

 

Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.

be accessible for

service.

Gas line is hard-plumbed. Have a flexible C.S.A international approved metal appliance

 

connector installed.

Entire range or oven

Make sure cord/plug is plugged tightly into outlet.

does not operate.

 

Service wiring is not complete. Call an authorized servicer.

 

Electrical power outage. Check house lights to be sure. Call your local electric company for

 

service.

 

 

Cooktop control

An error message will be displayed (glowing “Er”) at power up (or after a power failure) if ANY

displays any E code

of the surface control knobs were left in the ON positions (Figure 8). If a power failure should

error (ex.: E014)

occur, be sure to set all of the surface control knobs to the OFF position. This will reset the

 

surface controls.

 

Also, if the induction sensors cannot detect a pan made of the correct material or if the pan is

 

not centered properly or if the pan is too small, the power level will flash in the in the digital

 

display and the pan will not heat. After 3 minutes, an “Er” error code will be displayed until the

 

controls are set to OFF.

 

If the surface controls do not function and the “ER” message remains in any display after following

 

these procedures, contact your authorized servicer for assistance.

 

Cooktop control has detected a fault or error condition. Try turning electrical power supply

 

OFF and back ON to the appliance in order to reset main controls. If fault recurs, record fault

 

number and unplug the appliance.

Oven control beeps

Electronic control has detected a fault condition. Press CANCEL to clear the display and

and displays any F

stop beeping. Reprogram oven. If fault recurs, record fault number. Press CANCEL and call

code error (ex.: F11)

an authorized servicer for assistance.

Oven light does not

Replace or tighten bulb. See Changing Oven Light section in this Use & Care Guide.

work.

Electrical power outage. Check house lights to be sure. Call your local electric company for service.

Surface unit does

No power to the appliance. Check steps under "Entire Range or Oven Does Not Operate" in

not heat.

this Before you Call checklist.

 

No cookware was placed on the induction cooking zones or the cookware material type is

 

incorrect for induction cooking.

 

Incorrect control setting. Make sure the correct control is on for the surface unit to be used.

Surface units too

Incorrect control setting. Make sure the correct control is on for the surface unit to be used.

hot or not hot

Lightweight or warped pans used. Use only flat, evenly balanced, medium or heavyweight

enough.

cookware. Flat pans heat better than warped pans. Cookware materials and weight of the

 

material affect heating. Heavy-and medium- weight pans heat evenly. Because lightweight

 

pans heat unevenly, foods may burn easily.

Drip bowls are

Foods with acids, such as tomatoes, if allowed to stand in/on bowls will cause corrosion.

pitting or rusting.

Remove and wash drip bowls as soon as possible after spillover.

 

Normal environment. Houses along sea coast are exposed to salt air. Protect bowls as much

 

as possible from direct exposure to salt air.

42

Page 42
Image 42
Frigidaire FPCS3085LF manual Occurrence Possible CAUSE/SOLUTION

FPCS3085LF specifications

The Frigidaire FPCS3085LF is a state-of-the-art refrigerator that combines sleek design with advanced features, making it a standout choice for any modern kitchen. This side-by-side refrigerator offers ample storage capacity and innovative technologies that enhance both convenience and performance.

One of the most notable features of the FPCS3085LF is its large capacity, providing over 30 cubic feet of storage space. This ensures that users have plenty of room for fresh groceries, beverages, and frozen foods. The flexible storage options include adjustable shelves and door bins, allowing for easy organization and access to items. With the ability to fit large items such as party platters and tall bottles, this refrigerator truly caters to a variety of needs.

Technology plays a crucial role in the functionality of the FPCS3085LF. With the sophisticated PureSource Ultra II water filtration system, this refrigerator ensures that users have access to clean and great-tasting water and ice. The system is designed to reduce contaminants commonly found in tap water, providing peace of mind with every sip. Additionally, the Ice Maker feature efficiently produces ice, so users never have to worry about running out, especially during gatherings and events.

The FPCS3085LF also incorporates advanced temperature management features, including electronic controls and a multi-airflow system that helps maintain consistent temperatures throughout the refrigerator and freezer compartments. This technology ensures that food stays fresh for longer periods, reducing waste and keeping your groceries in optimal condition.

Another standout characteristic is the fridge's Energy Star certification, which signifies that it meets strict energy efficiency guidelines. This not only helps in reducing energy costs but also minimizes the environmental impact, making it a smart choice for eco-conscious consumers.

Design-wise, the Frigidaire FPCS3085LF features a fingerprint-resistant stainless steel finish that adds a touch of elegance to any kitchen while minimizing smudges and fingerprints. The LED lighting brightens up the interior, allowing users to easily locate items without straining their eyes.

In summary, the Frigidaire FPCS3085LF is a well-rounded refrigerator that combines spacious storage, cutting-edge technology, and stylish design. Its features and efficiency make it an excellent addition to any home, catering to the needs of families and individuals alike. With the FPCS3085LF, users can trust that they're making an investment in quality and performance that will last for years to come.