BEFORE SETTING SURFACE CONTROLS
PLACEMENT OF BURNER HEADS AND CAPS
Round Style Burners
The burner cap lip (See Fig. 1) should fit snug into the center of burner head and rest level. Refer to Figs. 2 &
3 for correct and incorrect burner cap placement. Once in place, you may check the fit by gently sliding the burner cap from side to side (page 6, fig. 2) to be sure it is centered and firmly seated. When the burner cap lip makes contact inside the center of the burner head you will be able to feel it . Please note that the burner cap should NOT move off the center of the burner head when sliding from side to side.
Burner Cap
Double Ring Style Burners
The Double Ring burner only operates properly with two burner caps in place. Be sure the burner cap lips are positioned facing down towards the burner head (Fig. 4) and into the recessed areas (Fig. 5) on each side of the burner head. Be sure both burner caps are seated firmly and rest level on the burner head before operating.
Check the fit for each cap using the same method for the round burner caps by gently sliding each cap from side to side. Please note that the burner cap lips should NOT move out of recessed areas of the burner head.
Burner Head
Burner Cap Lip
Fig. 4
Burner Caps
Fig. 1
|
| Recessed area |
Correct Burner Cap | Incorrect Burner Cap |
|
Placement | Placement |
|
Fig. 2 | Fig. 3 | Burner Head |
|
|
Fig. 5
7
