Operating Instructions
Operating Instructions
(continued)
REMOTE SENSING FEATURE (on some models):LIGHT pulsing ( On & Off intermittently ).DO THIS:PRESS REMOTESENSING
START BUTTON
NOTE: Unit display shows the set temperatureNote: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use the “ ” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. lf the unit does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the unit.
FAULT CODES:
If the display reads "AS" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
If the display reads "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
TO CHANGE TEMPERATURE DISPLAY: |
| YOU WILL SEE: | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DO THIS:
PRESS AND HOLD THE
UP/DOWN BUTTONS
TOGETHER FOR 3 SECONDS
Note: The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius.
8
2009 Electrolux Home Products, Inc.
All rights reserved.