AUTOMATIC ICE AND WATER DISPENSER
AUTOMATIC ICE & WATER DISPENSER OPERATING INSTRUCTIONS
1 2 3 4
56
Features may vary according to model.
Crushed | Press the Crushed Touch Pad | 1 | to get crushed ice. A red indicator will appear above the Touch Pad. Press glass against | |
| ICE dispensing paddle | 5 as far up as possible to catch all ice. | ||
|
|
| ||
Cubed | Press the Cubed Touch Pad 2 | to get cubed ice. A red indicator will appear above the Touch Pad. Press glass against ICE | ||
| dispensing paddle 5 | as far up as possible to catch all ice. | ||
|
|
| ||
Light On | Press the Light On Touch Pad | 3 to turn on dispenser light. A red indicator will appear above the Touch Pad. | ||
|
|
|
| |
Light Off | Press the Light Off Touch Pad | 4 | to turn off dispenser light. A red indicator will appear above the Touch Pad. | |
|
| |||
WATER | To operate the water dispenser, press a glass against the WATER dispensing paddle 6 . To stop dispensing water, pull | |||
| the glass away from the dispensing paddle 6 . Dispensed water is not cold. For colder water, add crushed ice or cubes | |||
| before dispensing water. A drip tray located at the base of the dispenser catches small spills and allows them to evaporate. | |||
| This drip tray is removable and dishwasher safe. Do not pour water and excess ice in this area because there is no drain. | |||
|
|
|
|
|
HOWTHE WATER DISPENSER WORKS
The water tank, located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed. For proper dispenser operation, the recommended supply water pressure should fall between 30 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take about 1½ minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device that will stop the water flow after 3 minutes of continuous use.
HOW THE ICE DISPENSER WORKS
The ice maker and container are located in the top of the freezer compartment. After the refrigerator is installed properly and has cooled for several hours, the ice maker can begin making ice within 24 hours. Air in new plumbing lines may cause the ice maker to cycle two or three times before making a full tray of ice. To begin ice production, lower the wire signal arm to the "down" or ON position. With no usage it will take approximately 2 days to fill the ice container. The ice maker turns off automatically when the ice container becomes full. To stop the ice maker, lift the wire signal arm until it clicks, and locks in the "up" or OFF position.
Simply release the dispenser paddle to reset the shutoff mechanism.
CAUTION
Water pressure must not exceed 100 lbs. Excessive pressure may cause water filter to malfunction.
Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected to soft water, ensure that the softener is maintained and working properly.
Because of new plumbing connections, the first production of ice cubes may be discolored or have an odd flavor. These should be discarded until the cubes made are free of discoloration and taste.
ON
OFF
Wire
Signal Arm
10