Cleaningthe ICE Dispenser

AUTOMATIC ICE AND WATER DISPENSER

CAUTION

If the dispensing paddle is pushed for more than 4 minutes, the dispenser motor may overload and stop. The overload protector will reset automatically after 3 or 4 minutes.

•If a large quantity of ice is needed at one time, it is best to remove cubes directly from the ice container.

•The following sounds are normal when the ice maker is operating:

•Motor running

•Ice dropping into ice container

•Water valve opening or closing

•Ice loosening from tray

•Running water

•Stop the ice maker when cleaning the freezer and during vacations.

•If the ice maker will be turned off for a long period of time, turn the water supply valve to the closed position.

Clean the dispenser and ice container at regular intervals, particularly before you take a vacation or move, or if the ice dispenser sticks.

1.Stop ice production by lifting the wire signal arm to the "up" or OFF position (side mounted) or the ice maker’s On/ Off power switch turned Off-set to the “O” position (rear mounted) .

2.Remove ice container by lifting up and out. Empty and carefully clean the container with mild detergent. Rinse with clear water. Do not use harsh or abrasive cleaners. Allow ice container to dry completely before replacing in the freezer.

3.Remove ice chips and clean the shelf and chute that supports the ice container.

4.Replace the ice container. Lower the wire signal arm on the ice maker to the "down" or ON position (side mounted) or the ice maker’s On/Off power switch is turned On-set to the “I” position. (rear mounted)and the ice maker will resume production.

WARNING

Do not use the ice chute as a handle when removing or replacing the ice storage bin. Surfaces there may be sharp.

Do not put fingers up ice chute.

Surfaces there may be sharp.

IMPORTANT

When removing or replacing the ice bin, do not rotate the auger in the ice bin. If the auger is accidentally turned, you must realign the auger by turning it in 90° turns until the ice bin fits into place with the drive mechanism.

Remove and empty the ice storage bin if:

1.An extended power failure (one hour or longer) causes ice cubes in the ice storage bin to melt and freeze together and jam the dispenser mechanism.

2.The ice dispenser is not used frequently. Ice cubes will freeze together in the bin and jam the dispenser mechanism. Remove the ice storage bin and shake to loosen the cubes.

CAUTION

NEVER use an ice pick or similar sharp instrument to break up the ice.This could damage the ice storage bin and dispenser mechanism.