PREPARE THE LOCATION
Style 3 - Cut Openings for 3¼” x 10” (8.3 x 25.4 cm) Rectangular Vent Transition to Round Vent
Roof Venting
To make a circular vent opening on the underside of the cabinet top:
1.Mark a centerline on the underside of the top of cabinet. .Mark a line 5” (12.7 cm) from the back wall on the
underside of the top of cabinet.
.Use a compass or a circle template to draw a circle with a diameter of 7½” (19 cm).
Use saber or keyhole saw to cut the circular vent
opening.Centerline Ø 7½”
(19 cm)
*5”
(12.7 cm)
Cabinet cutouts
*From wall, not cabinet frame
Style 4 - Cut Openings for 7” (17.8 cm) Round Vent to Round Vent Transition
Roof Venting
To make a circular vent opening on the underside of the cabinet top:
NOTE: The 7” round transition kit, part number 5304487139, is required for this installation.
1.Mark a centerline on the underside of the top of cabinet. .Mark a line 5” (12.7 cm) from the back wall on the
underside of the top of cabinet.
.Use a compass or a circle template to draw a circle with a diameter of 7½” (19 cm).
Use saber or keyhole saw to cut the circular vent opening.
4.Repeat steps
cabinet. | *Ø 7½” | Centerline |
| (19 cm) |
|
|
| * |
*5” |
|
(12.7 cm) | Cabinet |
| |
* | cutouts |
| |
*From wall, not |
|
cabinet frame |
|
Install Vent System
1.Install vent through the vent opening in upper cabinet or wall. Complete venting system according to the selected venting method. See “Venting Requirements” section.
.Use caulking to seal exterior wall or roof opening around the cap.
INSTALL RANGE HOOD (Ducted version)
NOTE
Your model will have a 3¼” x 10” (8.3 x 25.4 cm) rectangular vent connector on the inside of the range hood.
1.Unpack the 3¼” x 10” (8.3 x 25.4 cm) rectangular vent from the inside of your range hood. To detach the vent connector, remove the 2 installation screws
(.35x .95cm) and keep the screws in a safe place to reinstall later (see Step 5).
A. 3¼” x 10” (8.3 x 25.4 cm) rectangular vent damper | A |
| |
B. 3.5 x 9.5 mm screws |
|
B
.Lift the range hood up under cabinet and determine final location by centering beneath cabinet. Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood (See slot dimensions on page 6). Set range hood aside on a covered surface.
A
A
A. Keyhole slot
10