Frigidaire P/N 134296400A (0404) Electrical Connections For 3-WIRE System

GREEN
GROUND
SCREW	SILVER TERMINAL

GREEN

NEUTRAL

GROUND

WIRE

NUT

TIGHTEN NUT

TO THESE

THREADS

STRAIN
RELIEF
MOUNTING
BRACKET	POWER CORD

ELECTRICAL CONNECTIONS

FOR 3-WIRE SYSTEM

Non-Canadian ELECTRIC Dryer

1.Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner.

2.Install a U.L. approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time.

3.Thread a U.L. approved 30 amp. power cord, NEMA 10-30 Type SRDT, through the strain relief.

4.Attach the power cord neutral (center wire) conductor to the silver colored center terminal on the terminal block. Tighten the screw securely.

5.Attach the remaining two power cord outer conductors to the outer brass colored terminals on the terminal block. Tighten both screws securely.

Do not make a sharp bend or crimp wiring/ conductor at connections.

6.Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten screws securely.

7.Tighten the screws securing the cord restraint firmly against the power cord.

8.Tighten the strain relief nut securely so that the strain relief does not turn.

9.Reinstall the terminal block cover.

	GREEN POWER	CORD
GREEN
	GROUND WIRE		SILVER TERMINAL
GROUND
SCREW				TERMINAL BLOCK

GREEN			TIGHTEN
		BLACK
NEUTRAL
			NUT
GROUND
			TO THESE
WIRE	WHITE
			THREADS

NUT

RED

STRAIN

RELIEF

MOUNTING

BRACKET

POWER

CORD

ELECTRICAL CONNECTIONS

FOR 4-WIRE SYSTEM

Non-Canadian ELECTRIC Dryer

1.Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner.

2.Install a U.L. approved strain relief in the entry hole of the mounting bracket. Finger tighten the nut only at this time.

3.Remove the green neutral ground wire from the green ground screw located above the terminal block.

TYPICAL 4

CONDUCTORBLACK 240V

RECEPTACLE

	WHITE NEUTRAL
	RED 240V
TYPICAL 4
CONDUCTOR CORD
	GRE	EN GROUND

30 AMP NEMA 14-30 TYPE SRDT OR ST

4.Thread a U.L. approved 30 amp power cord, NEMA 14-30 type ST or SRDT through the strain relief.

5.Attach the green power cord ground wire to the cabinet with the green ground screw.

6.Attach the white (neutral) power cord conductor from the power cord and the green ground wire from the dryer harness to the silver-colored center terminal on the terminal block. Tighten the screw securely.

7.Attach the red and black power cord conductors to the outer brass-colored terminals on the terminal block.

Do not make a sharp bend or crimp wiring/ conductor at the connections.

8.Tighten the screws securing the cord restraint firmly against the power cord.

9.Tighten the strain relief nut securely so the strain relief does not turn.

10.Reinstall the terminal block access cover.

8