Frigidaire GL30WC4IES Prepare Hood Location Prepare Hood Location, Prepare The Hood, 3¼” X 10”

PREPARE HOOD LOCATION PREPARE HOOD LOCATION

ROOF CAP	3¼" X 10" or
	7" ROUND DUCT
	(For vertical
	discharge)
SOFFIT
	HOUSE WIRING
CABINET	(Top or Back of hood)

WALL CAP

HOOD

24" - 30" ABOVE	3¼" X 10" DUCT
COOKING SURFACE
	(For horizontal discharge)

1	Determine whether hood will discharge vertically (3¼” x 10”
	or 7” Round), or horizontally (3¼” x 10” only). For vertical or
	horizontal discharge, run ductwork between the hood loca-
	tion and a roof cap or wall cap. For best results, use a mini-
	mum number of transitons and elbows.
2	Use diagrams, below, for proper placement of ductwork and
	electrical cutout in cabinet or wall. For a non-ducted installa-
	tion, DO NOT cut a duct access hole.

HOOD MOUNTING SCREWS (4)			3¼” X 10”
			VERTICAL DUCTING
1315/16" (30" hood)
1615/16" (36" hood)		1315/16" (30" hood)
		1615/16" (36" hood)
CABINET FRONT
		7½"
	CABINET BOTTOM
	5¼"	5¼"	2"	10½"
	VERTICAL DUCT
5"	ACCESS HOLE
	1¼"			1½"

		ELECTRICAL
WOOD SHIMS		ACCESS HOLE
	CENTER
(recessed-bottom		(in cabinet bottom)
	LINE
cabinets only)

7” ROUND

VERTICAL DUCTING

3 Run house wiring between service panel and hood location.

PREPARE THE HOOD

7” ROUND

DUCT PLATE

1 Remove 7” Round Duct Plate from top of hood. Set duct plate aside - with mounting screws.

WOOD SHIMS			3¼” X 10”
(recessed-bottom		HORIZONTAL DUCTING
cabinets only)	CABINET FRONT
			1/8" ¾"
3¾"	HORIZONTAL DUCT
	ACCESS HOLE
CABINET
	5¼"	5¼"
BOTTOM
1315/16" (30" hood)		7½"
		1315/16" (30" hood)
1615/16" (36" hood)
		1615/16" (36" hood)
HOOD			ELECTRICAL
MOUNTING	CENTER
			ACCESS HOLE
SCREWS (4)

LINE (in wall)

FILTERS

2 Remove tape holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside.

2