PREPARE THE HOOD |
| PREPARE THE HOOD |
3 Remove
Teflon® is a registered trademark of DuPont.
(Held in place with 2 screws)
4 | Remove |
| Damper/Duct |
| Connector |
| from inside |
| the hood. Set |
| connector |
| aside - with |
| mounting |
| screws and |
| parts bag. |
DAMPER/
DUCT
CONNECTOR
5 | Remove |
| either top or |
| back wiring |
| knockout and |
| install |
| approved |
Electrical
Cable Clamp.
ELECTRICAL CABLE CLAMP
7 | Remove Air |
| Chute - held in |
| place with one |
| (1) screw. |
NOTE: Be careful not to disconnect any wires.
8 | Remove Baffle |
| from air chute. |
AIR CHUTE
➠
BAFFLEBAFFLE
➠
➠
Non-Ducted Installation - Skip to Step 15.
| (3) #8 SCREWS | LIGHT |
The following |
| PANEL |
|
| |
Steps (6 thru | (2) #8 SCREWS |
|
14) are for |
| |
|
| |
DUCTED |
|
|
INSTALLATION |
|
|
ONLY. |
|
|
6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
9 |
10
Rotate baffle. Reinsert baffle into air chute (as shown) so that baffle tabs fit all the way into slots in air chute. An audible “click” will be heard when fully installed. This will close off the air flow through the
SLOTS
➠
NOTE: Be careful not to trap wires between support fin and light panel.
TABS
➠
SUPPORT FIN
3