Frymaster FPD65

FRYMASTER FPD65 SERIES GAS FRYERS

CHAPTER 3: INSTALLATION

3-8

3.3.1 Specifications

3.3.1.1 Adjustments to Different Gas Types

Gas Adjustments

Gas Type Natural LP

Manifold Pressure† 4" W.C.*/10 mbar* 11" W.C.*/27.5 mbar*

Orifice Diameter Model Specific Mode l Spec if ic

Burner Marking None None

Pilot Marking 26N (P/N 810-0811) 16LP (P/N 810-2400)

* Gas pressure may vary per fryer model and altitude. Check the ratin g plate for specif ic

gas pressures.

NOTE: Outlet gas pressure must be adjusted strictly within the above requirements 5 to 10 minutes

after the appliance is operating.

† For controls and adjustments, please refer to the "gas valve" illustration on page 3-9. (Pilot Flame

Adjustment: Turn the pilot adjustment screw clockwise/counter-clockwise until the desired flame-

volume is achieved.)

3.3.2 Gas Conversion Procedures

DANGER

This appliance was configured at the factory for a specific type of gas. Converting

from one gas type to another requires the installation of specific gas-conversion

components.

Switching to a different type of gas without installing the proper conversion

components may result in fire or explosion. NEVER ATTACH THIS APPLIANCE TO A

GAS SUPPLY FOR WHICH IT IS NOT CONFIGURED!

Conversion of this appliance from one type of gas to another should only be

performed by qualified, licensed, and authorized installation or service personnel, as

defined in Section 1.6 of this manual.

Contents

Main *8196039**8196039* FPD65 Series with Built-In Filtration Frymaster FPD65 Series Gas Fryers Installation & Operation Manual Please read all sections of this manual and retain for future reference. Page TABLE OF CONTENTS Page # Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 1: INTRODUCTION 1.4 Computer Information (cont.) 1.5 Safety Information 1.6 Service Personnel Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 2: IMPORTANT INFORMATION 2.1 Receiving and Unpacking Equipment 2.2 General 2.3 Principles of Operation 2.4 Rating Plate 2.5 Pre-Installation 2.5 Pre-Installation (cont.) 2.6 Air Supply and Ventilation 2.7 Equipment Installed at High Altitudes Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 3: INSTALLATION 3-1 3.1 Installing the Fryer FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 3: INSTALLATION 3-2 FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 3: INSTALLATION 3-3 3.1 Installing the Fryer (cont.) 3.2 Gas Connections Page Page 3.2 Gas Connections (cont.) 3.3 Adjustments/Adaptation To Different Gases Contact factory with the following information when performing conversions: 3.4 Electrical Connections Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 4: FRYER OPERATIONS 4.1 Initial Start-up Page 4.2 Boil-Out Procedure 4.2 Boil-Out Procedure (cont.) 4.3 Final Preparation For additional computer instructions, see computer manual that came with frying system. Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 5: FILTRATION OPERATION 5.1 General 5.2 Filtration Preparation Page Page 5.3 Daily Filtration Operation Page 5.4 Operating the Filter Page Page Page Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 6: PREVENTATIVE MAINTENANCE 6.1 General Page Page Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 7: TROUBLESHOOTING 7.1 General 7.2 Pilot Burner Malfunction 7.2 Pilot Burner Malfunction (cont.) 7.3 Main Burner Malfunctions 7.3 Main Burner Malfunctions (cont.) CHAPTER 7: TROUBLESHOOTING 7-4 7.4 Wiring Diagram, Main 8051481A J2 GAS CM4-S COMPUTER 7.5 Wiring Diagram, Filter MOTOR Page Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 8: PARTS LIST 8-2 8.1 Cabinetry and Related Components (cont.) Page Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 8: PARTS LIST 8-5 8.3 Frypots, Burners and Related Components (cont.) FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 8: PARTS LIST CM4-S 8-6 8.4 Component Box Components Page Page FRYMASTER FPD65 SERIES GAS FRYERS CHAPTER 8: PARTS LIST 8-9 8.6 Oil-Drain Components (cont.) 8.7 Oil-Return Components 8.7 Oil-Return Components (cont.) 8.8 Suction Tube, Oil-Return Components 8.8 Suction Tube, Oil-Return Components (cont.)