a.Place the saddle in the clamp and adjust to the desired angle.
b.The adjusting bolt on the bottom side of the head of the seat post requires a 6mm allen key. Recommended torque is 100
c.If the nose is tilted at an undesirable angle, loosen the 6mm allen bolt slightly and reset the angle of the seat. Once desired seat angle is achieved, tighten 6mm allen bolt per torque specs.
4.SEAT POST HEIGHT ADJUSTMENT / TORQUE
Once the desired angle of the saddle has been adjusted, place the seat post at the required height for proper leg extension. Using an allen head, tighten seat post clamp to recommended torque spec.
NOTE: Recommended torque is 50
All Fuji carbon seat posts are marked with a minimum insertion line. This is the minimum amount of insertion required for the seat post to remain structurally safe. Some frames will require additional insertion to ensure that the frame remains structurally sound as well. The base of the seat post should be inserted enough into the seat tube to extend below the bottom of the top tube.
Warning: Fuji carbon seat posts are made to be lightweight, and are not suitable for all riders and all possible uses. If the rider is approaching 250 lbs/113.4 kg in weight, Fuji recommends against the use of this seat post. This seat post should be used only for road riding and not mountain bike use. Failure to follow this warning may result in a catastrophic failure of the seat post, causing serious personal injury or death.
Warning: Seat post is NOT to be extended beyond the minimum insertion line. Extension beyond the minimum line can result in failure, causing serious injury or death.
Warning: It may be visually difficult to identify damage to the composite material. If the external composite surface is dented, frayed, gouged, deeply scratched, fractured, chipped or otherwise damaged, the component should be replaced. If seat post has been involved in a crash or impact, even if there is no visible damage, Fuji or an authorized Fuji dealer should inspect the product.
