V I . C O M F O R T A D J U S T M E N T S
To adjust the ELR footrest height:
1.Remove the two screws from the side of each leg rest extension. See figure 28.
2.Loosen the bolt on the side of each leg rest extension.
3.Slide the leg rest in or out to the desired length.
4.Tighten the bolt and reinstall the two screws on each leg rest extension.
RECLINING SEAT OPTION
If your Jazzy is equipped with a reclining seat, you can adjust the seatback angle and the armrest angle.
To adjust the seat back angle:
1.Press down on the seatback release lever. See figure 29.
2.Move the seatback down or up to the desired position.
3.Release the seatback release lever.
To adjust the armrest angle:
1.Push down on the armrest release lever. See figure 30.
2.Move the armrest up or down to the desired position.
POWER ELEVATING SEAT OPTION
If your Jazzy is equipped with a power elevating seat, you can change the seat height automatically. The seat height switch is located either on the armrest (Pilot controller) or on the joystick (Remote Plus controller).
To change the seat height:
1.Press forward on the power seat switch to raise the seat. See figure 31.
2.Pull back on the power seat switch to lower the seat.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches the top or bottom limit.
LEG REST
RELEASE LEVERADJUSTMENT SCREWS
LEG REST
ADJUSTMENT
BOLT
Figure 27. Elevating Leg Rests | Figure 28. Elevating Leg Rests |
26 | www.pridemobility.com | Jazzy 1100/RevJ/Feb03 |
