I V . T H E J A Z Z Y 1 1 0 0
ELECTRONICS TRAY
The electronics tray is located on the rear of your Jazzy. A section of the electronics tray is exposed through the body shroud. The rest of the electronics tray is located underneath the rear door. The electronics tray consists of the ammeter, the battery charger cord, the main circuit breaker, the lighting harness connectors (optional equipment), optional power seat connectors, and the controller harness connectors.
νAmmeter: The ammeter displays the charger’s current output in amps. See figure 6. For more information, see IX. “Batteries and Charging” in this manual.
νBattery charger cord: This cord is used when- ever your battery needs recharging. See figure 4.
νMain circuit breaker: The main circuit breaker is a safety feature built into your Jazzy 1100. See figure 7. When the batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and the electronics. If the circuit trips, allow your Jazzy to “rest” for approximately one minute. Next, push down the circuit breaker but- ton, turn on the joystick controller, and continue normal operation. If the main circuit breaker con- tinues to trip repeatedly, contact your authorized Pride provider.
νLighting harness connector (optional): This is where the optional lighting harness connects to the controller. See figure 8.
νController harness connectors: This is where the joystick connects to the motors, batteries, and charger. If your Jazzy is equipped with a Remote Plus or Europa controller, there is only one con- nector on the tray. If your Jazzy is equipped with a Pilot controller, there are two connectors on the tray. See figure 4.
νPower seat connector: This is for the optional power seat switch. See figure 4.
STANDARD HEADLIGHT/
TAILLIGHT CONNECTOR
MAIN CIRCUIT BREAKER
Figure 7. Main Circuit Breaker
FULL LIGHTING HARNESS CONNECTOR
Figure 8. Full Lighting Harness Connector
18 | www.pridemobility.com | Jazzy 1100/RevJ/Feb03 |
