21
1
REMOVING THE SmartMedia™
20
LOADING THE SmartMedia™
1
Push the SmartMedia into the slot slightly and
allow it to pop back out. It can then be pulled out
easily.
➀Check that the indicator in the viewfinder is
green and then switch the camera off.
➁Release the SmartMedia cover lock as shown
in the figure.
Never open the SmartMedia slot cover while
the camera is switched on.This could destroy
the image data or damage the SmartMedia
itself.
●
!
See P.22 for information on switching the camera on
and off.
2
SmartMedia™
➀Check that the camera is switched off and
open the slot cover.
➁Push the SmartMedia firmly into the SmartMedia
slot as far as it will go.
➂Close the slot cover.
●
!
If you open the slot cover while the camera is
switched on, the camera is automatically switched
off to protect the SmartMedia.
●
!
The SmartMedia will not slide fully into the slot if it is
inserted facing the wrong way. Be careful not to
apply undue force to the SmartMedia.
■ Only use 3.3V SmartMedia
MG-4S ( 4MB), MG-16SW ( 16MB, ID)
MG-8S ( 8MB), MG-32SW ( 32MB, ID)
MG-16S (16MB), MG-64SW ( 64MB, ID)
MG-32S (32MB), MG-128SW (128MB, ID)
MG-64S (64MB)
●
!
Images cannot be recorded or erased if a write-
protect sticker is affixed to the SmartMedia.
●
!
Operation of this camera is only guaranteed when it
is used with FUJIFILM SmartMedia.
●
!
Some 3.3V SmartMedia are labelled as “3V” cards.
●
!
See P.115 for more information on SmartMedia.
●
➀●
➀
●
➁
●
➁
●
➂
●See P.86, 108 for information on printing
images.
●See P.101–108 for information on
downloading
images to a PC.
◆Printing Images and Downloading
Images to a PC ◆
●
!
To protect the SmartMedia, always store it in the
special anti-static case.