117116
Warning Displays eThe table below lists the warnings that are displayed on the LCD monitor
Warning Displayed Explanation Remedy
The camera battery is low on charge.
No SmartMedia is loaded, or it is
loaded incorrectly.
•
The SmartMedia is not formatted.
• The SmartMedia terminals are
soiled.
• The SmartMedia terminals are
soiled.
• The SmartMedia is damaged.
• The SmartMedia format is
incorrect.
The SmartMedia is fully recorded.
The SmartMedia is write-protected.
•
An attempt was made to playback a
frame not recorded on this camera.
• The SmartMedia terminals are
soiled.
Replace or recharge the battery.
Load the SmartMedia (3.3V) in the correct
direction.
• Format the SmartMedia.
• Wipe the contact area on the SmartMedia
with a soft dry cloth.
Wipe the contact area on the SmartMedia
with a soft dry cloth. It may be necessary to
format the SmartMedia. If the error message
is still displayed, replace the SmartMedia.
Use a SmartMedia that is not write-protected.
• Images cannot be played back.
•
Wipe the contact surface on the SmartMedia
thoroughly with a soft, dry cloth. In some cases,
you may have to format the SmartMedia.
Erase some images or use a SmartMedia
that has ample free space.
LCD Monitor
display
panel
Notes on the SmartMedia™
●Do not use or store SmartMedia in very hot, humid or
corrosive environments.
●Take care not to touch the SmartMedia’s contact area
or allow the area to become soiled. Use a dry lint-free
cloth to wipe away any soiling that does occur.
●To avoid damage caused by static electricity, always
use the special static-free case provided during
transportation or storage, or keep the SmartMedia in
a storage case if available.
●Do not carry SmartMedia in locations such as a
trouser pocket. This could subject the SmartMedia to
excessive force when you sit down, thereby
damaging the SmartMedia.
●The SmartMedia may feel warm when it is removed
from the camera after extended periods of picture
taking or image viewing. This is normal and does not
indicate a fault.
●Inserting a SmartMedia that is charged with static
electricity into your camera may result in a camera
malfunction. If this occurs, switch the camera off and
then on again.
●Affix the label onto the designated area of the card.
Do not use third-party labels as this can lead to
problems when the card is inserted or removed.
●When you attach the label, take care that it does not
cover any of the write-protect area.
■Notes on Using SmartMedia with a PC
●If you intend to take photos using a SmartMedia that
has been used on a PC, format the SmartMedia on
your camera.
●When you format a SmartMedia in the camera and
then shoot and record images, a directory (folder) is
automatically created. Image data is then recorded in
this directory.
●Do not change or delete the directory (folder) names
or file names on the SmartMedia from your PC as this
will make it impossible to use the SmartMedia in your
camera.
●Always use the camera to erase image data on a
SmartMedia.
●To edit image data, copy the image data to the PC’s
hard disk and then edit the copied data.
■Specifications
Type
Image memory card for digital cameras
(SmartMedia)
Operating voltage 3.3V
Operating conditions
Temperature:
0°C to +40°C (+32°F to +104°F)
Humidity:
80% or less (condensation free)
Dimensions 37 mm ×45 mm ×0.76 mm
(1.45 in. ×1.77 in. ×0.03 in.) (W ×H ×D)
(Lit red)