2
1
4
3
LOADING THE BATTERY
Your camera uses one 3V lithium battery, type CR2/DL CR2.
To load the battery.
1Move the battery cover release knob.
2 Open the battery cover.
3Insert the battery following instruction in the diagram on the inside of the battery cover paying particular attention to the position of the , and . poles of the bat-
tery. The battery must be inserted the right way or the camera will not function.
4When the battery is inserted correctly, close the battery compartment cover by
∗ | pressing it until it snaps into place. |
|
Do not apply excessive force when opening or closing the battery cover. |
| |
∗ | One fresh lithium battery should be sufficient for approximately 250 exposures (based on our |
|
∗ | test conditions). |
|
When traveling, take extra batteries to provide power for extra exposures. This is particularly |
| |
∗ | important if you visit areas where fresh batteries may be difficult to obtain. |
|
Check the battery capacity symbol before using your camera. (→p.17) |
| |
∗ | After changing the batteries, reset the date to assure accurate date/time recording. (→p.18) | 15 |
|
|
